Not having done a great deal of domestic installation as such, only in my younger years, could someone please advise me?
I have my 17th edition update and am about to take Part P tomorrow then on to Insp & Test. I am aware of all the normal implications of being registered etc.
What is the official stance for running twin and earth under floorboard with regard to clipping and support. I fully understand that in a loft etc where its more accessible then where it can be clipped, then this will happen, but under a floor where cables pass through joists at 50mm below the top level and then need to turn parallel to the joist, how can the cable/s be supported as in the regs every 150mm for 1mmsq without ripping every other floorboard up across a room which would cause unnecessary damage to a floor?
Any help would be great guys.
Thanks all.
epgri
I have my 17th edition update and am about to take Part P tomorrow then on to Insp & Test. I am aware of all the normal implications of being registered etc.
What is the official stance for running twin and earth under floorboard with regard to clipping and support. I fully understand that in a loft etc where its more accessible then where it can be clipped, then this will happen, but under a floor where cables pass through joists at 50mm below the top level and then need to turn parallel to the joist, how can the cable/s be supported as in the regs every 150mm for 1mmsq without ripping every other floorboard up across a room which would cause unnecessary damage to a floor?
Any help would be great guys.
Thanks all.
epgri
