acvc
-
- Joined
- Jun 1, 2008
- Messages
- 435
- Reaction score
- 26
Morning guys.
Can anyone clarify this for me?
From this schematic, is it asking me to:
1. put in a link between L and L at the incoming side, and
2. put in a link between L and A (to feed the SL out) on the outgoing side?
Or is it just showing me the internal volt-free switching between L and A, and no links are required?
I'm only getting the heating to fire up when I bypass the switching at the receiver, i.e. put a link in between the incoming L and B (which then goes to the valve etc.). It's just not firing up when the programmer calls for it. HW is fine.
Many Thanks (again).
Can anyone clarify this for me?
From this schematic, is it asking me to:
1. put in a link between L and L at the incoming side, and
2. put in a link between L and A (to feed the SL out) on the outgoing side?
Or is it just showing me the internal volt-free switching between L and A, and no links are required?
I'm only getting the heating to fire up when I bypass the switching at the receiver, i.e. put a link in between the incoming L and B (which then goes to the valve etc.). It's just not firing up when the programmer calls for it. HW is fine.
Many Thanks (again).