Search results | Page 6

Search results

  1. Flanders

    Ip4x cant get 32mm grommets

    Tool station sell them https://www.toolstation.com/membrane-cable-entries-kit/p10433?store=ER&utm_source=googleshopping&utm_medium=feed&utm_campaign=googleshoppingfeed&gclid=CjwKCAjwm7mEBhBsEiwA_of-TBhnoiDXhIkaXy8se_aeNgpi87GoxudP-expvMWMyFFw1_vPpx8efxoCfikQAvD_BwE
  2. Flanders

    Electrical installation age

    Yes very good Article . I did no know that accessories had dates on them .
  3. Flanders

    EICR questions

    Agree with above should be code 3 for no rcd in a flat except possibly the bathroom light which may need an rcbo fitting .looks like you need a couple of down lights and a new switch for the water heater. It's a good chance that you dont require the bonding under the kitchen sink. From the...
  4. Flanders

    Help with storage heaters on eicr

    You can buy dual tariff boards you would just need 1 contactor to control the off peak side
  5. Flanders

    UK First consumer unit change.

    Yes correct the only way to test them at the board is to connect a short piece of cable to them . So general easy to test them at a socket on the circuit .
  6. Flanders

    UK First consumer unit change.

    Yes you only need to test the rcd for the rcd results, that way you get a clean result. The circuit is not relevant for the rcd test
  7. Flanders

    UK First consumer unit change.

    Nice job . Regards the rcd test . Did you check if there was any load on the circuit because if there was it can give you false results. Fridges still plugged into circuits are always favourite for giving high rcd reading. I always try and test rcds before connecting the outgoing circuits .
  8. Flanders

    Observing fire detection shortfalls on EICRs

    Not sure you could give it code 1 . As a code 1 constitutes an immediate danger, there will only be a dangerous situation if the building catches of fire and the smoke alarm does not inform the occupier. So that would be a potential danger. You do have a good point about reg 560.10. Though
  9. Flanders

    Observing fire detection shortfalls on EICRs

    I have mention on EICRs if a mains powered smoke detector is damaged or missing and wrote it down as info on the report. I would only code it if it was electrical unsafe ( if there was exposed live parts for example) as others have said there is no requirement in an EICR to confirm the fire...
  10. Flanders

    Fitting Sockets.

    I have never used a tool bend cables, using pliers can damage the insulation, as others have said dress in tha cables neatly with your hands and you should not have a problem.
  11. Flanders

    Company Van/Previous Disqualification

    Best ask the question before you go to any interview. It may be that the company van insurance will cost a lot more so they may not want to employ you on that basis. On the other hand they will appreciate honesty and may not be an issue. We had a guy come for a job. . Managed to blag his way...
  12. Flanders

    Wylex 6A plugin MCB

    Screwfix and cef do sell them . But as others have said best check the circuit It could be one circuit on 2 mcbs
  13. Flanders

    EICR - No Line or CPC Continuity on Ring

    I think the confusion comes from the fact to rectify a brocken ring requires investigation and further testing. But this is an EICR and you are reporting on the condition of the installation. So in this case a brocken ring has been identified. Which will become dangerous if the circuit is...
  14. Flanders

    Landlord EICR's

    You raise an interesting point. Sounds like a get around. The problem. Is there would be no paper trail . You would have a unsatisfactory and a satisfactory report for the same property just a couple of weeks apart with no reference to any remedial work All ok until something goes wrong and...
  15. Flanders

    How do you like to pull wire?

    As others have said all depends. general i would pull the cable from the end with the least bends and or holes . If you puting a cable over 20 floors you would drop down the riser not try and pull it up .
  16. Flanders

    RCD requirements for TT?

    Think its table 41.5 with an earth loop of 100 ohms or less you can use a 500ma rcd
  17. Flanders

    Minor works certification

    If your moving the socket then you are altering the circuit. So yes a minor works cert is required
  18. Flanders

    Are you allowed to Switch off and Lock off a dangerous imstallation?

    Yes it does not make sense , we should at least be able to report to a governing that has the Authority.
  19. Flanders

    Are you allowed to Switch off and Lock off a dangerous imstallation?

    We had a situation last year with a Take away with very unsafe electrics, code 1s every where,after getting advice all we could do was hand deliver a danger notice recommending them to turn the power off until it was made safe that they signed for .We could not lock off the power, the best we...
  20. Flanders

    Microwaves and kettles all failed Class 1 test

    As above what test failed how did they fail was is high resistance or no continuity

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top