Search results
Click here to remove these ads

Search results

  1. OutOfTheGame

    New outbuilding question.

    That may well make the decision for me but I put the conduit there is straight down the wall with one 90° bend about one foot from the end. I guess once the boards are up and it won't go I could just go cavity route? I was just trying to discuss to see if there were any better ideas out there...
  2. OutOfTheGame

    New outbuilding question.

    Hi, thanks for replying. The existing conduit is a dissused one that basically comes down the inside of an internal wall and pops out in a wiska box mounted on the outside of the building, I would terminate it in there. That drop is about 2M, the sections before and after that drop would...
  4. OutOfTheGame

    New outbuilding question.

    Thanks for all the ideas. what is the concensus on best way to run the cable? Method 1, 2 or 3?
  5. OutOfTheGame

    New outbuilding question.

    It could be either to be honest, easiest to do inside but if I choose inside I would have to put under floorboards so not easy to inspect, I could join it in an ip rated box on the outer wall and fill with raytech gel but then there is the question of what terminals to use inside?
  7. OutOfTheGame

    New outbuilding question.

    Possibly although it will be under floor boards so not "inspectable" but good idea as can get 100a rated fairly easily. Could do a resin joint it I guess as they don't require inspection, but it would be indoors
  8. OutOfTheGame

    New outbuilding question.

    The board end will remain SWA it's easy to get too it's the opposite end where it drops down the inside of the outside wall for around 2m. It comes out into a wiska box that used to supply my shed it's no longer needed hence the secondary joint question.
  10. OutOfTheGame

    New outbuilding question.

    Trial with some offcuts
  11. 20240710_200813.jpg

    20240710_200813.jpg

    • OutOfTheGame
    • Media item
    • Comments: 0
    • Category: Electrical Videos
  13. OutOfTheGame

    New outbuilding question.

    Hi, I tried with 3 cores of 16mm2 cables from an offcut of the 2 core I have and they do go down with room to spare.
  14. OutOfTheGame

    New outbuilding question.

    First post and I'm looking for some advice if someone would be so kind.....I am a qualified electrician but it's been a long time (17 years) I've been in management so be kind 🙃 I'm looking for some advice I have an outbuilding that I wish to run a cable to. The cable I ran is a new 16mm2 2...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tilers Community
This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top