Search results

Search results

  1. M

    Costing running 3 phase motors

    Been asked to cost the running a number of motors . Was going two amp test each phase and multiple by line neutral voltage to get kWh . Is this correct .ta
  2. M

    Soft starter

    Cheers Westward
  3. M

    Soft starter

    Yep fitting a five pin isolator . Am in the same boat just moved house can't find any of my books , which hasn't been a issues as only done repairs in the last few months and can only find a old sixteen edition that someone gave me
  4. M

    Soft starter

    It feels wrong to design a circuit that will be double it's maximum earth fault . I know you will come across it from time to time and will code it as such , but I can't think of a reg that covers me for knowingly putting a cable in with a incorrect value . I know sometime after deign a circuit...
  5. M

    Soft starter

    You could have a point . I've worked on bailers before and had issues when starting up and the main pump has tripped , had to be reset and worked fine after the startup . I do see that peak in the final push but the startup on the main pump huge . The board is rccb protected I could TT it at...
  6. M

    Soft starter

    Been to have a quick look at a possible job . Five pin point putting in to feed waste compactor . The nearest board it could come off is a bout a120 meters run . Took a earth loop test at board 0.55 . If I ran 10mm 5 core am in ok for volt drop and a calculated earth loop of 0.99 (could be a...
  7. M

    Anyone seen these Wago connectors before.

    Used a ideal inline today . Removed old sw and put new switch connected to the d/b the line from the MCB was a bit short so used one to go into the switch and then new single back to MCB
  8. M

    Ordered myself some new toys today

    Not a fan of DeWalt . But I love a kit . What price did you get it for
  9. M

    Loft conversion sub main & diversity

    You could come off the main board with a MCB (if the board is rcd protect ed)
  10. M

    Merry Christmas to you all

    Shut down crimbo day off if am lucky
  11. M

    Good electricians hand book?

    Alan lynch the part p doctor second fix is a good around book
  12. M

    Pipe and cable detector

    Have a Bosch one , and has been said not a lot of use ,cant trust it. Have a couple of powerful magnets for finding studs
  13. M

    Armeg acceler recommend

    Yep and they have springs on the ends to force the cut out off . I feel like am a salesman for them .
  14. M

    Armeg acceler recommend

    I normally use bocsh cutters with the quick swap , but was so impressed with these.
  15. M

    Forum adverts..........................

    Is she male , will have a look into that. In for a penny
  16. M

    Armeg acceler recommend

    What other views on these holecutter . Bought a pack a 3 about a month a go and have used them for the first time this week and have to say , one of the best buys of late . Very pricey but such a clean cut and very strange using a impact drill on steel.
  17. M

    Currys refused to install my daughter's cooker, but....

    Did they leave you the cable to connect with
  18. M

    Which putty for emergency fix of water pipe?

    As had been said it's hard to solder pipe with any water in it as steam will put hole in your seal . The best way is to use Yorkshire fitting couplers and it their is little play in the pipe cut a section out and when refitting the section file out the stop point in the couplers so you can slid...
  19. M

    Junction box- 3 core & earth conundrum

    I still can't. See this black connectto the yellow

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top