I know this is probably very simple for a lot of you, but I just can't get it to work right right. I've been close, but no cigar. I disconnected the switches because I painted the walls and I can't remember how I had them wired. There are two 3-way switches that control two exterior lights...
This weekend I was replacing a hall light fixture in my old home (rewired circa 1980/90's) and noticed the work was done using one of the exposed ground wires as one of the switch leg/loop travelers on a 3-way. Obviously, this is completely wrong and a fire hazard, so I decided to try to rework...
Hi everyone. I bought one of those smart switches, specifically the Kasa 3 way kit (HS210 KIT).
But when I opened my 3 way dumb switches I see only those wires:
Downstairs switch:
One wire: black, red, white coming out. Those are connected to the switch.
Upstairs switch
Two wires:
One wire...
I was wondering if someone could assist me in determining whether I can replace my current 3-way switch configuration with an Enbrighten smart switch setup. I have provided photos of everything relevant.
The first switch box, which has only one 14-3 cable entering it, is depicted in an attached...
I took a light down to put up a new fixture and now the light goes on but the switch doesn’t shut the light off. The power only stays on so I am quite confused. It is a 3 way switch. Both switches will not turn the light off. The wiring “appears” to be 14/2 to fixture and 14/2 out of fixture...
I have a three way switch going to my downstairs but I’d like to add an outlet to the top of the stairs switch if possible. I’d also like to add a light to the bottom of the stairs as well but that is for later if it is even possible. Any help or advice would be appreciated. The part that...
Hoping someone might find this a challenging puzzle - I'd be grateful for any help and sorry in advance for the lengthy description!
I think I’ve inherited some creative wiring.
I need to replace a 3-way switch on a circuit that worked fine for years. When I removed the old switch, I found 5...
As I tried to summarize in the title, I'm having an interesting buzzing issue in a residential home.
Problem: When Lights are turned on, all 3 switches controlling the same load start to buzz, as well as the breaker the lighting circuit is on. Buzzing stops on all devices and the breaker when...
Hi, really stumped here. I went to replace an overhead light with a ceiling fan/light combo and got it working, but then the rest of the room didn't have power.
The fixture has power to it and then goes to a 3-way switch. In the photo, the middle black is hot and the right one is not...the...
Hello all
I need help with an electrical issue I think which is coming at my house
I have a 2 three way switch to control a light fixture in my house. Initially the 1 switch was not working so I tried to flip it multiple time, then went to another switch and light started. Again I went to my...
I am trying to replace a 3-way switch that has 2 switches on it. Total is 3 sets of 2 switches each.
Switch I am removing has a red and black wire that go to 2 black screws on the right side. Off has both switches to the left.
On the left side there is a black wire connected to the bottom of...
Hi, I am trying to wire a smart 3-way switch but the manual diagram does not make sense. Attached are photos of my existing switches and the wiring diagram from the manual. Which of my existing 3-ways do I swap out and which wires go where?
Thanks, I’ll owe you!
I've installed some recessed lights in my den, where previously there was just a fan with a light fixture running off a single switch.
Now there are 4 switches; 2 for the recessed lights and 2 for the fan, at different entrances to the room. But I can't seem to get them running independently...
A friend had a contractor remove a half wall with 2 can lights, multiple 3 way switches and a receptacle. By the time I was involved everything was disconnected and 3 cables of 12-3 were hanging out of the ceiling along with several cables of 12-2. There are a lot of things going on in this...
I just replaced a 3-way switch. I am 99.9% sure I wired it the same as the existing switch. Now, when this switch is in the down position the other switch works properly. When the other switch is in the up position the new switch works properly. In any other position nothing works. I connected...
Struggling with adding a 3-way switch. I have a feed with 2 wire, a 2 wire to the light, and a 3 way ran just to my new switch in one box; a simple over head light, and my second switch box with just the one 3 wire. My question is how exactly to wire at each switch, all I seem to get is power...
Current situation: Great room is greatly deprived of light in one-half of the room.
Solution: Add two recessed lights to the current figuration.
I'm not sure how exactly to connect the new lights to the existing lights. I have seen where some explain to connect directly to one light and not...
On my landing are three connected lights. They have 230v LED bulbs. There are three switches - one obviously an intermediate switch. In one of the four 'off' arrangements of the switches, the LEDs glow faintly. Does anyone have a theory on where this current might be leaking to? Thanks.
Hello,
Total newbie here and as you can tell from my name..... I'm definitely not an electrician. I've done a bit of electrical hackery in the past, mostly in cars and a bit of soldering, but this all feels a bit beyond my ability and I'd rather not be electrocuted and die before my 30th...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc