Keeping this brief.....................New dwelling.....TT system with 100mA S type rcd protected supply to local board with 30mA RCD. Freelance "engineer" to commission Heat-Pump, as original company disappeared before installation. ASHP worked for a while then tripped the 100mA RCD not the...
My mother moved into her three bed home in 1960 and it had underfloor heating in the living room. I remember we used it when I was growing up in the 70s but it hasn't been used for probably 30 years. Electric storage heaters were installed to take advantage of the old off-peak electric tariff...
Hi guys
We are due to undertake a new build install where they are using air source. Its the first air source I have installed so need a bit of guidance from you professionals, not getting any help or wiring diagrams from the plumber so reliant on your knowledge.
The heating system is full...
Listening to the radio the other day, and UK govt has announce no new gas boilers to be sold by 2035 and everyone should go with ASHP... £5k grant to get one..Let me add... only england and wales. We'll stick with peat up here for now.
The following questions.
Probably easy to answer, but just...
Wiring a new extension and the clients are having Air Source Heating in their house, I'm waiting to see what supply is required for it from the supplier (clients are finding out for me, guessing at 32A) but have seen people suggest using a Type C RCBO (they are already having a new board, full...
Hi - No idea if I am writing in the right place. Please, I cannot get a straight answer when the temperature is 0- -20 Celsius - where can I find a chart of what normal KWhr consumption is?
I think mine is using far too much electricity
thanks
Hi there,
I have an air source heat pump with a few issues:
1. It gets stuck on defrost mode. When it goes to defrost, it gets stuck and ends up becoming an air conditioner in the depths of winter (fun). I suspect this may be a faulty valve (or what ever reverses the coolant) getting stuck on...
My NIBE F2015 air source heat pump which is only 7 years old has an apparent fan motor failure. The fan turns freely and the motor starter capacitor has been replaced but the unit will still not run. Any suggestions for a fix?
Hi
Just signed up to see if anyone can point me in the right direction with air source heat pump for my above ground pool. It stopped working a few weeks ago and I thought the display unit had gone. However I've tried to replace it but that doesn't power up either. I've had the top off it and...
Hi,
I install a few heat pumps in a domestic situation from time to time. I have recently started renovating an old 1800s cottage which has no access to mains gas which made me think about putting in an air source heat pump. I was looking at an ecoDan as I've been told they are best on the...
Hi all,
Has anyone installed this air source heat pump. I found it on ebay
12000 BTU HEAT PUMP INVERTER SPLIT AIR CONDITIONING CONDITIONER WALL MOUNT UNIT | eBay -...
Hi Chaps
Starting 3 new builds shortly.
Had brief chat with plumber today over phone, mentioned that an air source heat pump will be part of the set up.
Pressurised system with buffer tank, UFH ground floor & rads first floor.
It's a first but never had anything to do with air source heat...
Hello all
im currently first fixing for a Mitsubishi outdoor unit- puhz-sw120vha indoor unit-ehscmec
the system has an air course unit located outside, joule cylinder in loft, hydro box next to fuseboard
manifold for under floor heating downstairs which I have ran all my three core wires for...
Recently notice a drop in performance of one of my heat pumps used for heating hot water.
The normal temp rise through the HP is around 8 degrees C but has recently dropped to around 3 degrees C.
The pressure guage shows approx 100psi with the HP OFF rising to approx with the HP ON but I don't...
hi
I have wired up various central heating systems, y-plan, s-plan, under flooor etc . but i will be doing an air source heat system. They have not yet purchased the pump, but i am on with first fixing and i am wanting some advice on what cables are needed before any of the plans / instructions...
I have a CH/HW system with 6 stats, some of which are programmable all at £240V. They control my Oil Fired boiler System.
I am having an ASHP fitted which I want to control with the existing 240V timer/stat control system.
The ASHP has a pair of terminals (Currently looped) as part of its 12V...
Giona UK - Electric Water Heaters
Hot water only. 900 watt pump on the 300 litre version. COP of 2.98
http://gionauk.com/downloads/Direct%20Air%20Source%20Heat%20Pump%20Water%20Heater.pdf
Am told this is new tech because it combines the heat pump with a cylinder.
Will it get MCS?
Will there...
Spinball
Thread
airsource
heat
heat pump
hybrid
mcs
new
pump
source
though
thoughts
Evening folks....
We don't install ASHP. So looking for some advice.
Does a property need to be a Band D to qualify for RHI in the same way as FITs.
I was surveying a property today for a pv system Old stone built 1905 house off mains gas grid. Sent their by their son whom we installed a...
On Air Source Heat pumps there is a signal flex going from the Pump all the way to the Cylinder,
It's 0.75mm Flex and I'm getting two opinions about whether it can be run in containment (YT2 and 20mm conduit) with the feed.
The spark is saying that it can on 5Kw pumps (2.5mm T&E for the feed)...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc