Hi all, need to pick the collective brains as im concerned about a recent problem. We have a few freezers here on our small holding and one of them started playing silly buggers. Eventually the 20A MCB kept tripping so to make sure it was the freezer i put it on a different circuit with a 16A...
Was wondering why was BS1361 replaced by BS88 even though BS1361 tends to have a larger breaking capacity according to the on-site guide if I'm reading it right, however, I maybe wrong.
For example BS1361 breaking capacity can be 16.5kA to 33kA depending on what type you get, where BS88 is 16kA...
Afternoon Guys. Question from an out of date retired electrician.
Existing Hager split-board using cartridge fuses (1361) for OC protection.
Existing shower circuit (6mm) protected by 30amp cartridge fuse for old possibly 7'5kw shower unit.
Shower being replaced with a 8.5kw shower unit. Are...
Hi, mrs cleaning cooker and pulled knob off to clean underneath, this fell apart and when I tried to put it back together it tripped the electrics, the fuse is an old cartridge style, just wondering if I can replace this for a mcb/rcd? It has 2 slats that run horizontal rather then vertical...
Just how much current can a 13 amp fuse potentially (no pun intended) pass?
I've seen loads plugged into fused multi-ways in excess of 3120 watts and wondered if anyone had ever tested this.
New here so sorry if this has been asked to death!:waving:
hello, I am doing the wiring in 8 flats and a comunal area.
i have 3 phase supply at the bottom and i am wondering if i can put the 3 phases into a 4 way DB first. then i am thinking to leave meter tails coming out of the trunking for each meter which will be installed.
is this something i can...
Ok, my flat was built in about
1960, it has a very old wylex fuse box for which the fuse for the heating and
power is one switch. The lights have blown but I still have power.
In
the past when the fuse has blown the power and lighting has been lost so
therefore the fuse has not blown this...
I have been to a call out today regarding an old cartridge fuse consumer unit. The customer said that the fuse went bang yesterday and she lost her Lounge, dining and one socket in the hallway (there is two but the other is on a different circuit). I went round and tested the circuit and found...
Hello guys this is my first post as I'm only recently qualified (but doing the job for 4 years) . But my question is as my title suggests. Is it acceptable to add 80A 30mA incoming RCD before a cartridge fuse board but the wiring is still in compliance (pvc/pvc, csa's etc). They don't want to...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc