domestic testing

domestic testing

  1. CopiamElectrical

    Ring circuit fault, High RN

    Hey there, Sorry I’ve just joined up. I’m a qualified electrician/Electrical engineer. Recently sat my 2391-52. My question is I had a fault which I couldn’t find or rectify during a periodic test that I carried out yesterday (tenant property) occupied. Circuit: Ground Floor Socket 32A...
  2. ancienthistory

    UK Water leak, do we need a "dryness check" before re-testing the electrics?

    Hello, you all helped me out recently when we had a water leak (mostly in kitchen ceiling), and my landlord's contractor was saying the household circuits couldn't even be tested for 28 days after the leak due to a "28 day rule". Thank you so much for educating me about that! Here is the...
  3. ancienthistory

    Turning consumer unit on after water damage

    Hello wise electricians of the world! I am in the UK. Recently we had a water leak which caused some damage in our home, we are currently trying to dry everything out. The water certainly affected at least some electrical circuits (e.g. water was coming through kitchen ceiling spot lights.) My...
  4. M

    Erroneous test during pre testing

    Hi, While doing the Erroneous test during my pre test I came across abit of a headache. When I was doing a lighting circuit it was coming in a short eg. 0.04ohms but once I disconnected an LED light in a bathroom it went away, same with socket circuits which had USB sockets connected on them, is...
  5. Dave Appleby

    Ok. So.... How do I log this for an EICR?

    Right. Any suggestions how to split this out on a schedule of tests? New sheet for each section? Buggered if I have a clue.
  6. D

    Is it ok to do insulation resistance test on RCBO at 500v?

    I know you are not supposed to do a insulation test on circuits that are protected by an RCD at 500v because it may damage the electronic components inside the RCD so that's why you switch the RCD off before you test the individual circuits, however, what if the circuits are all protected by...
  7. D

    Continuity testing with Fluke 1663

    Hi all, I was testing a domestic premises In Ireland during the week for Continuity, pre-connection. usong the Fluke 1663 megger, I had a small issue during the day related to the mA setting on f4. During continuity testing you can set to 10mA or 250mA. My question is which is the correct...
  8. B

    Domestic testing

    Hi can anyone take me through step by step of best way to test a domestic board and explain how to do tests as I know how to do most of them but not 100 percent I'm a 1st year apprentice so just looking for help thanks
  9. N

    Basic domestic testing Qs

    I'm just look for confirmation thoughts on this first point. I think when IR testing on an existing installation and it’s not practical to remove all vulnerable equipment. I can connect L to N to earth and test at 500V on the circuit I’m testing. The question is if I do the above...
  10. S

    Non domestic testing.

    Hello all, Does anyone know what is required in order to test non domestic premesis? The problem is that I use a good friend of mine to do all of my private work tests. He is registered with NICEIC as a domestic installer and therefore cannot test work in commercial or industrial properties...
  11. C

    Domestic testing

    Hi everyone it's my first time on this site and I have a couple of questions so here goes. Has any one used the niceic cert software and is it easy to use and would they recommend it and what's the going prices of carrying out pir's on domestic properties. I've worked for a company for 20 years...
  12. ringer

    Wandering lead for domestic testing

    Would you recommend buying a ready-made reel such as the ETL30 or should I get some green-sleeved single? If so, what csa should it be, can you buy a 30m reel of single, or is 50m a better length? And would the single come on a suitable/usable reel?
  13. R

    Domestic testing proceedures

    Are there any good websites online showing the full domestic circuit test procedures to meet the 17th edition requirments, diagrams and methods for all the tests. Voltage and Frequency Wiring Polarity Checker Insulation resistance (fault/ short circuit current) ContinuityLoop Impedence RCD...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top