Hi All,
During my exercises on paper, we always assume the source from grid has Tension and Currentnin phase.
Today, for the first time, I was learning about Diesel Genset and noticed its plate saying 2700 MVA / 2000 MW. So basically, somehow a source has its own Power Factor (PF).
1. Can...
Hi guys/gals… just pondering a gennie set up in a domestic that has a double pole changeover switch with 25mm tails in from dno and 25mm out to cu, 4mm cable then supplies the gennie male socket. Two queries i have, should the 4mm t&e have overload protection (all be it would be downstream)? And...
Hi all
I hope everyone is doing well.
I have a new rural small house coming up that I need to use generator power for.
It's 105 sqm and the time and cost to get connected to the grid need to be pushed out for me. (1-2 years)
Has anyone any experience with some type of battery connected to a...
Got a client who asked me for advice he has 10 bunka bin pods each with a 10amp load ( water heater) and a 30 amp maximum demand with sockets and has asked me what KVA generator to get if any one can give me advice so I could pass information on that would be wonderful
Help requested with 11kV, 3MW generator. Our generator has just returned from a major overhaul, and we are in the process of recommissioning the set. The setup is that the generator supplies power onto a common busbar in parallel with the DNO supply. We supply site load and export any excess...
Hi guys, been wiring up a 3ph 20kva generator set and auto transfer switch, mains supply is 3ph TN-C-S 80a cut outs, the set is a Perkins with deep sea electronics 6120 controller. The set runs ok until I turn on the circuit (ring final) that has the ups's in the server room on, the load is...
spidersparks
Thread
circuit
controller
generatorgeneratorset
problem
ups
voltage
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc