Hello All
I have an Axpert MKS 4 (conversol Re badge) 5.5 Kw inverter that I have had in and running for a little over a year. From the start it played up and I had a couple of f12 dc-dc overcurrent faults that re set and carried on working, with a little fettling of the charge current and...
Good morning,
I'm on the road year round in a motorhome with two 100w solar panels (soon to be doubled) charging a 260ah AGM battery via a 20a MPPT charge controller. I also hook up a 30a multi stage mains charger about once a week to properly charge the battery.
I'd like to get the most out...
Hey everyone! I am drafting out my first solar power off grid system for my back yard shed and came here in hope to get some good recommendations from you guys on trusted a charge controller which will support my current specs but also give me room to grow as I improve on this system. Below are...
Hi there,
I just purchased a sailboat and its electrical system was put together in questionable ways..
It came with an 815W array of mismatched PV panels, linked to a Xantrex C40 (40A) PWM charge controller, charging a 1030Ah 12V lithium battery bank.
First question: can mismatched panels...
I need to wire up my solar panels to my motorhome leisure batteries.
I have a 160W permanently mounted panel that will be hard wired to my MPPT controller.
I will occasionally wish to add a portable 100W panel to the setup.
Can I connect this portable panel directly into the MPPT as well when...
Trimglafix
Thread
alternator
battery
charging
how to
mppt
panel
panels
voltage
Hi all,
I need to perform the following pid control using an altivar312, want to read the DC bus voltage (that is the solar panels voltage), and use a pid control to keep this voltage constant in order to make a mppt follower. The idea is to change the frequency driven to the motor. If dc bus...
Hi,
I'm looking to create a small solar panel system (80w panel) and am looking at a 10A MPPT controller off ebay which has good reviews. However, it does not specify compatible battery types and I was wondering if an AGM battery of around 35ah would work with it? I searched around just before...
Hi
I have a system of 3.45 kW with 20 photovoltaic panels (LG 235 M1C-C2 ) and two strings; one oriented to the East and other one to West (10 panels E and 10 panels W). The slope of my roof is + / - 25º. I have a Sunny Boy 3300 with one MPPT. I consider a hypothesis to change to another one...
Hi all I have just had a 3920KW Sharp 16 X 245W panels fitted with a Solar River SR4K4TLA1 inverter.
There are 2 strings. One is currently reading around 330V and the other is just below 200V.
6 of the panels are landscape and 10 are portrait. I have since found out that 6 are on one string...
garty611
Thread
electricians' talk
installed
inverter
mppt
panels
solar
strings
voltage
volts
A few days ago I had installed a sunny boy 4000tl inverter. 16 suntech stp240s-20wd panels 8 east and 8 west (2strings) 3.84kWp
The display alternates between strings. But string 2 shows 0v always.
The system has been generating between 1kWh and 3.4kWh per day.
They are going to come out...
I have an overstock of 4 of these very handy inverters. they are german made, excellent quality, IP rated, with a wide voltage range but most important they have a dual MPPT which is well handy given the current lack of power one inverters out there.
cost is £1200 +VAT, buyer collects...
moggy1968
Thread
change
electricians' talk
electrics
for sale
inverter
inverters
mppt
power
tripping
I am quoting for a small job where the roof changes pitch and has a dormer, In 240W panels I cound get 1680W on one string and 960W on another. Anyone know of a small dual mppt inverter that could manage that?
Regards
Bruce
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc