I have never installed a fixture that uses a screw terminal block before and could use some guidance. Since the earth wire is connected to I screw the grounding wire in the same terminal and then connect the blue wire to the white and the brown to the black?
Hi. I have had to cut a cable in order to feed it through a wall. Then I plan to reattach it once through. At the moment I am using a standard terminal block however it looks messy as it's bulky and I have to use electrical tape.
I was wondering if I could use one of these...
I'm trying to wire up a new Logik oven and it has a non-standard terminal block, much smaller than that on the oven I just replaced and all the YouTube videos I could find. It looks like you just screw the electrical wires in directly. So, I guess I should remove the connectors and screw the...
Does anyone know where I can get an earth terminal block like this in the UK: https://www.leroymerlin.fr/v3/p/produits/repartiteur-de-terre-p-40-mm-michaud-e1401450424
Quickie - Would you say this is ok?
32A MCB feeding 6mm T&E which is then connected to a 2.5mm T&E & 1.5mm T&E cable via a 30A terminal block in plastic terminal block housing buried in stud wall.
The 2.5mm feeds a 3kW immersion heater with 13A SFU at the heater end.
The 1.5mm feeds gas boiler...
Hi, I'm a council tenant and just had some work done in my kitchen, which included a new electrical installation. There was previously a single sockets ring main, and a new kitchen sockets ring main was added, which in itself seems fine. But I'm concerned about the pre-existing ring main. This...
Amateur question here (and I may have picked the incorrect subforum too)
I want to attach a single common ground to 12 separate buttons, with individual wires rather than daisy-chaining them. I'm wondering what the best tool for this would be. In my mind I have pictured a terminal block, but...
Hi All,
I have just fit 10mm splash backs in my kitchen bringing the sockets out by the same distance. On one of the double sockets I now have barely enough cable to work with and connect to the socket, I have 3 lives, neutrals and earths. Is it ok to use a terminal block to connect all like...
Hello,
Would anybody be kind enough to point me in the right direction on how I would energise this roller shutter
door motor to go one way or the other so I can start to design a control?
Thank you in advance for your help.
Hi chaps,
Does anyone know if there is a terminal block suitable to fit into a MEM memshield 1 series DB? It will be fused downstream, its just that there isnt physically enough room to fit a 40A Fuse holder in the board.
Either a description, web address, model number, or datasheet, or...
Hi all,
Query about Star Terminal Block Arrangements. On our notes online, it says “the start ends of each winding (aren't these U1, V1 and W1) must be connected together to form the star point and the finish ends connected to the 3-phase supply.” Should it not be the other way round, i.e. the...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc