Anyone installed a DYGIZONE lighting control system?

[hursty]

I have been called to a customers property and they have a controlled lighting detection system with PIR sensors and external lights.
They are having problems with lights not staying on and flicking lights.
They have two GJD DYGIZONE controllers in property and I have noticed both are operating as master controllers.
I was wondering whether anyone has installed these units?
Without anymore investigation I am presumming that the one controller is wired wrong and should be acting as the slave.
I will be returning to property soon and was wondering if anyone has any advise on these units?
From my brief visit I am alittle puzzled as the installation of the controllers are both wired from the control box rather than out to master and then master to slave.

Any tips or advise would be much appreciated before I visit this job.

Thanks

P.S sorry if this is in wrong section as alarms etc is private, so wasnt sure.

 

[hursty]

No one?

 

[ashrow]

hursty

i have only ever installed a GJD system once

It was 2 2 zone units interconnected to 2 key pads but have not any issues with them

You could always disconnect the so called slave controller but i do not see this as a issue, the pirs operate a contact inside the main unit to turn on the lights, perhaps the main unit is faulty ?
You can also press the number button on the keypads to over ride the pirs to see if the issue is with the lights themselves

Google GJD DYGIZONE for wiring diagrams

 

[hursty]

hi ashrow, thanks for response. I think I will start with what you mentioned, by disconnecting slave controller and see where we go from there, as the button function works fine to switch the lights on and off manually.
and get inside the main unit and check against wiring diagrams.

If the main unit is a different manufacture do you think this could be an issue? As i know the controllers were installed at a later date to the main unit and PIRs. untill i get there im unsure.

Thanks again