hie guys

[mannex]

i want to reposition some sockets to new height 450 and i have to flush fit them, here is my problem what can i use to fill and close the hole were the original socket was . i have 7 sockets to move

thanx guys

 

[Marvo]

Won't cement and plaster work?

 

[GLENNSPARK]

*removed*

 

[High Tower]

*removed*

Don't be so rude, if you have nothing polite or constructive to say then sthum!!

 

[Marvo]

Yes, agreed. I've removed the unnecessary post. Starting a slanging match just increases the workload for the staff so please don't.

 

[micknew]

Why hasn't this been put on the DIY forum?

 

[HandySparks]

A bit expensive for filling backboxes, but should do the job:

Toolstation > Painting & Decorating > Fillers & Putty > Deep Gap Filler

 

[telectrix]

one coat plaster from B&Q. however, if the cables come from below and need to be joined, get an electrician in to do the job.

 

[overskilled]

If the hole is deep...save money on plaster by mixing it 50/50 with sharp sand, fill to just below the surface then top coat with plaster (easifill 45 or similar...easifill 20 sets too quick), sand also makes the base layer stronger. Dampen the chase with water to slow the drying, make the plaster key better and avoids *most* cracking.