Honeywell Accenta G4 setting error

[mrfrank]

I have just installed a Honeywell Accenta G4 system. All ok apart from 2 queries:
The entry/exit zone 1 is a PIR (there are no door contacts on my system, just 2 PIR's) It is set to zone 1. The second PIR is in the lounge.
The system will set ok, but only after I am out of the range of the zone 1 PIR (exit). I think it should ignore the PIR during the exit time period but displays the message "setting error" and halts the timed exit until the PIR is clear.

The second query is the quick setting of the system when exiting the premises via a single keystroke without having to input 4 digits. Can not see in the book how to set it. It says it can be set to do this by the engineer (in this case me)
Thanks,
Frank

 

[geordie]

Which keypad do you have led or lcd

 

[Bob Geldoff1234]

Zone 1 is normally a door contact so it makes sense for the system not to set unless the door is shut.Using a PIR in zone 1 needs the PIR to turn off(just like the door) hence the setting error.
Can't help you with the other question...sorry.

 

[Pauls0212]

page 23 of engineers manual ... single key setting

 

[mrfrank]

Zone 1 is normally a door contact so it makes sense for the system not to set unless the door is shut.Using a PIR in zone 1 needs the PIR to turn off(just like the door) hence the setting error.
Can't help you with the other question...sorry.

Ok, thanks for the quick reply.
[automerge]1588152964[/automerge]

page 23 of engineers manual ... single key setting

Ok, thanks for the quick answer.