Rcd test on sub main

[swaley]

Hey guys do i need to do a full schedule of tests after installing a supply to garage with additional board.
Or do I only issue test results for the individual circuit i.e Garage.
I realise I would need a 2nd schedule of tests for the 2nd DB.

Also my 2nd DB has no RCD. So I presume I only document RCD when testing main DB on first schedule of results?? And not on 2nd DB in Results??

Hope this sounds clear??

 

[Octopus]

Schedule 1 needs to show the new sub main - where the existing board has circuits installed I state “used” and if they aren’t I use “spare”

Then as you say a full schedule for the garage dB

Regarding the red tests, I am assuming your sub main is coming off a dual red board.

And remember, the description of work on the first page is so important to clarify the scope of your works and changes

 

[swaley]

Regarding the red tests, I am assuming your sub main is coming off a dual red board.

Yes first board is dual RCD

 

[buzzlightyear]

how or what cable is it to the s/board ?

 

[Octopus]

Yes first board is dual RCD

So yes, rcd results on the first schedule, but no harm adding them on the 2nd schedule too

 

[swaley]

how or what cable is it to the s/board ?

6mm SWA exported TNS. 2 way board

 

[buzzlightyear]

delete

 

[buzzlightyear]

delete

 

[buzzlightyear]

6mm SWA exported TNS. 2 way board

you are good to go then.

 

[Octopus]

2 or 3 core swa?

 

[buzzlightyear]

2 or 3 core swa?

banjo or guitar ,black or white .

 

[swaley]

Would I need to document only the new circuit on first schedule of tests or the entire boards circuits? I.e existing cooker, shower etc... got my assesment on Friday flapping

 

[Toneyz]

Being that this is a domestic job what type of electrical certificate are you going to use?

 

[swaley]

Being that this is a domestic job what type of electrical certificate are you going to use?

EIC. I'm clear on 2nd schedule with 2nd board. But the first schedule not sure if I would need to document the whole board. My first thought would be only add the circuit I installed. Just need someone to clear it up

 

[Andy78]

Any certificate encompasses only what is written in the "Extent of installation covered by the certificate" section.
Only the work you have done needs to be on the certificate.