Re-wiring Honeywell thermostat

[Ahite]

Hello all

I need to re-wire my original Honeywell T6360B thermostat because the wireless version I replaced it with a few years ago is just so unreliable; But I need advice on which wire goes to which terminal.

I have the following wires: yellow, red, blue and yellow/green which need connecting to terminal points 1, 2, 3 and 4.

Thanks in advance for any wisdom. It's cold out there!

regards

ahite

 

[LlandrilloSpark]

Try this

http://www.bssindustrial.co.uk/download/366/T6360%20Room%20Thermostat.pdf

 

[telectrix]

and you'll need to remove the wireless receiver and connect the other end into the boiler.

 

[LlandrilloSpark]

Red (live) to 1, Blue (Neutral) to 2 and Yellow (Switched Live) to 3

That's how it should be wired but From here it's impossible to tell

 

[sima24]

Their is a honeywell app for android and iphone, with every wiring diagram for every honeywell product. Its free too

 

[Ahite]

Thanks LlandrilloSpark, but I am struggling with reading the diagrams. I am assuming live (red) to terminal 1, switched live (yellow) to terminal 3, neutral (blue) to terminal 2 and earth (yellow/green) to the earth terminal. This sound right?

 

[LlandrilloSpark]

That's how it should be wired but the problem you have is do you know red is actually permanent live, Blue is neutral and Yellow is switched live, if you do know for sure then connect it as above , if your not sure you need an electrician with a voltage indicator to find out for sure