Running cable over steel beams below chipboard floor

[Dave Sturgess]

My builders have left a 20mm gap above the steel beams supporting the new first floor by setting the timber joists 20mm above them.
Is it acceptable to run cables through the gap and over the beams?
Cheers
Dave

 

[Octopus]

Who is wiring and signing off the electrics?

 

[Pete999]

My builders have left a 20mm gap above the steel beams supporting the new first floor by setting the timber joists 20mm above them.
Is it acceptable to run cables through the gap and over the beams?
Cheers
Dave

Don't see whynot

 

[Midwest]

You could always get an oxy acetylene torch cutter.

 

[Rockingit]

My builders have left a 20mm gap above the steel beams supporting the new first floor by setting the timber joists 20mm above them.
Is it acceptable to run cables through the gap and over the beams?
Cheers
Dave

Turn the question around - why wouldn't it be OK?

 

[pirate]

If you wrap the cable round one of the steel beams, tightly, about 4 turns should do it, you might get Radio Luxembourg on a still night.

 

[telectrix]

If you wrap the cable round one of the steel beams, tightly, about 4 turns should do it, you might get Radio Luxembourg on a still night.

where have you been the last 30 years since lux. closed down?

 

[pirate]

Sailing the seven seas! Closed down??? They just went undercover, hence you need that "special" aerial.
You won't remember Stuart Henry on that wee radio boat off the East coast then?
Pirate radio...those were my days!

 

[Octopus]

My builders have left a 20mm gap above the steel beams supporting the new first floor by setting the timber joists 20mm above them.
Is it acceptable to run cables through the gap and over the beams?
Cheers
Dave

So the OP has been on, reviewed the thread and as yet updated it with any responses ...............

Very poor.

 

[The Ghost]

copy deleted.

 

[Wilko]

The question is - what does the steel beam support, if it isn't the floor? Is there any chance the cable could be trapped / crushed?

 

[Midwest]

So the OP has been on, reviewed the thread and as yet updated it with any responses ...............

Very poor.

Can you blame him/her with answers about cutting equipment & old radio stations

 

[Deleted member 26818]

Turn the question around - why wouldn't it be OK?

There is a requirement for cables above ceilings and below floors to be provided with extra protection if they pass through joists or battens.

 

[Rockingit]

There is a requirement for cables above ceilings and below floors to be provided with extra protection if they pass through joists or battens.

I get the impression that's not quite what's going on here - sounds to me like the builders have left a void. But..... was only trying to make the OP think for themselves.

 

[Midwest]

There is a requirement for cables above ceilings and below floors to be provided with extra protection if they pass through joists or battens.

Oopps, have I been missing a trick all these years?