SWA's and Eaton Memshield

[SparkyDips]

ok guys have got 3 x 20mm (Outside Diameter) cables coming into a switch room from ducting in ground. just wanted some ideas of dressing them. best to clip individually side by side or group the on some tray? what about if metal trunking was used to house them upto the dist board? they are being glanded off into a Eaton Memshield Type A SPN 7 Way dist. board.

cheers

 

[Sintra]

I would either go for cable tray or clip with perforated all round band. Both methods would look good. Personally I wouldn't use the trunking for SWA.

 

[plugsandsparks]

Depends how long the run is. I tend to go for best option for rating of cable & will it look good, so in some cases i have used tray, sometimes clipped using cleats cannot remember ever putting them in trunking though.

 

[SparkyDips]

Not sure about the perforated band, its ok when not in sight but not a fan of it when visible. Section of cable tray will be best me thinks.

Run is only about 2 meters.

 

[plugsandsparks]

If its straight, tray it, if its bendy cleat it

 

[telectrix]

just wanted some ideas of dressing them.


​short summer frock, stockings and suspenders, stiletto heels.

 

[SparkyDips]

just wanted some ideas of dressing them.


​short summer frock, stockings and suspenders, stiletto heels.

haha funny f##### tel, i dont want to be aroused whilst doing the job, electrical job that is!! lol

 

[Brightspark2]

From what you described Id say cable tray....

 

[SparkyDips]

yes i would like to use tray but the run isn't very long so will be cleating it.