Test reports!!

[michaelw6]

R1 + R2
when do you have to do it?
obviously on a new installation...but
on a periodic?
short install when doing a consumer unit change?
Who does what!
Also do you fill in your Max Permitted Zs and your Max Disconnection Times?

 

[albi]

R1 + R2 ......................................................................................yes
when do you have to do it? ...............................................................every time any work has been done
obviously on a new installation...but
on a periodic?
short install when doing a consumer unit change? ?????............................... who does what
Who does what!
Also do you fill in your Max Permitted Zs and your Max Disconnection Times?....... yes you do have to do it.

 

[michaelw6]

R1 + R2 ......................................................................................yes
when do you have to do it? ...............................................................every time any work has been done
obviously on a new installation...but
on a periodic?
short install when doing a consumer unit change? ?????............................... who does what
Who does what!
Also do you fill in your Max Permitted Zs and your Max Disconnection Times?....... yes you do have to do it.

maybe i should re prase this.

>R1 + R2<
---------------
when do you have to do it! obviously on a new installation...but...on a periodic? or short install when doing a consumer unit change? ?????
Who does what?
Also do you fill in your Max Permitted Zs and your Max Disconnection Times on your sheets as a must or optional because my sheets do not have these on.
thanks.

 

[Sintra]

maybe i should re prase this.

>R1 + R2<
---------------
when do you have to do it! obviously on a new installation...but...on a periodic? or short install when doing a consumer unit change? ?????
Who does what?
Also do you fill in your Max Permitted Zs and your Max Disconnection Times on your sheets as a must or optional because my sheets do not have these on.
thanks.

Yes you must do either an R1 + R2 or an R2 on a PIR. When doing a CU change i would test R1 + R2 or R2 before changing CU to make sure circuits are complete before change of CU.

I also fill in disconnection times and max permitted Zs as they are required on my sheets as i am NICEIC registered.