Veritas 8 part set problem

[jlohm]

I installed a veritas 8 with 5 texecom pir keypad and external bell box last week. I went to commission alarm system today and all was good but when I part set the system zones 6,7,8
Light up and makes a bleep sound then goes in to lock out the system is fully functional on full set I have installed veritas 8 many times before and not had this problem any ideas?
Cheers Jordan .

 

[Plonker 3]

Have you rang their technical support number to see if they can help?

 

[tazz]

Zones 6,7,8 are active when setting, so will need to include in part set zone omissions.

 

[jlohm]

I briefly tried omitting the zones I'm due to go back and do some wall lights on Saturday thanks for the support if that fails ill have a nice phone bill for calling tech support cheers

 

[extec]

A Part Set Suite defines the zones that will be automatically
included and excluded (omitted) when the system is part set.
From the Programming Menu, press 5 ( followed by the
suite number 1, 2, 3, or 4 (e.g. to program Part Set
Suite 2, enter 5,2. The zones currently active in the
selected part set will indicate (the omitted zones will remain
off).

Press the appropriate numbered button(s) of the
zone(s) to be included or excluded (omitted). Press
PROG. The system will chime to confirm that the new Part
Set Suite has been accepted. The system will then
automatically revert to the Programming Menu.

 

[johnsparks23]

Download an app that converts 08 numbers on your phone.