A
Apoll
Hi,
I am new in the forum, and as profession I am software developer, so please accept my apologies before hand, for lack of knowledge.
At work currently wrote a solution to communicate with a Wago 750-841. Sensor modules are working fine, as do the actuator modules (750-514).
However I was asked to make a working model of the layout of where the device going to be installed to test as 'real' as possible.
Sensors are ok. Connected few buttons and all working fine. However I do have issues for the output modules.
I cannot connect a light on them to show a a light or something that actually they operating. (other than the light on the controller but not good enough when the controller is in a box).
My question is, has someone worked with Wago 750-5xx, 2/4 channel output controllers? Can someone tell me how to manage to get a signal at least when the device comes on?
I used a multimeter, but no currents pass through the sockets as they so in the sensor units.
Thank you very much.
P
I am new in the forum, and as profession I am software developer, so please accept my apologies before hand, for lack of knowledge.
At work currently wrote a solution to communicate with a Wago 750-841. Sensor modules are working fine, as do the actuator modules (750-514).
However I was asked to make a working model of the layout of where the device going to be installed to test as 'real' as possible.
Sensors are ok. Connected few buttons and all working fine. However I do have issues for the output modules.
I cannot connect a light on them to show a a light or something that actually they operating. (other than the light on the controller but not good enough when the controller is in a box).
My question is, has someone worked with Wago 750-5xx, 2/4 channel output controllers? Can someone tell me how to manage to get a signal at least when the device comes on?
I used a multimeter, but no currents pass through the sockets as they so in the sensor units.
Thank you very much.
P
