Wire for oven spec advice

[Jolyonwag]

Looking for advice for fllowing:

Existing circuit info
Cable 6m x 2 + 2m on single 32 amp circuit from consumer unit to 32 amp rated witched neon spur 1m from distance from cooker, then
Cable 6m x 2 + 2m from switched spur to 32 amp JB behind cooker.

removed old cooked from JB

New cooker arrived with no lead!

required lead from JB to cooker need to be no longer than 500 mm long

Please, what is spec of cable (flex) required to join cooker to JB

Cooker is rated 32amp

Delonghi DSR 917 DFM
DUAL FUEL COOKER

Thank you in advance

 

[westward10]

This was moved from DIY so give helpful replies.

 

[Wilko]

Hi - looking at the specs, only the oven is electric and it’s rated load seems to be 3.1kW. So the flex can be 2.5mm2 or more. The cooker flex should be oil resistant. Hint - get Mr Gas Safe to use the long gas flex hose and match the electrical flex to its length. That way the cooker can be pulled forward (to clean behind) without stressing them.

 

[MJPD29]

If you check the manufacturers instructions it usually states what cable to use with that particular model.