Hive single channel receiver wiring

Jamie' · Jan 6, 2018

Hi all,

Looking to wire up a hive receiver but never done one on a job before (just finished 4 year apprentachip flat/house bashing mainly) so just want to check I'm going to be doing it right before going ahead.

So i was going to run a 3 core T&E from the boiler to the receiver.

So at boiler end:
1) remove link from 1&2 at boiler.
2) brown into 2
3) Grey tagged blue to N
4) black tagged brown into 1

Receiver end:
1) brown to L
2) link L to common
3) Grey tagged blue to N
4) black tagged brown into N/O

Am I correct in thinking this would work or is something wrong!

Thanks in advance for the help.

[ElectriciansForums.net] Hive single channel receiver wiring

Andy-1960 · Jan 6, 2018

Hi Jamie, yes I think what you are suggesting should work.

buzzlightyear · Jan 6, 2018

don't mess It up could be a expensive boiler part mother board .

Madocks · Jan 7, 2018

Personally I would run a 5 core flex instead. Then its simply power and 2 switch wires

Also probe the switch, most of the time theres already 230v there so no need to cross link the common.

SparkyChick · Jan 7, 2018

Just looked at the image of the wiring diagram which I'm guessing is inside the boiler cavity.... did anyone else pickup the fact it appears to have a fuse in both the line and neutral? Or am I misreading it?

And as an aside, whatever cable you use to connect to the boiler, it should be heat resistant, and I agree with @Madocks . I'd use a five core HR flex.

Toneyz · Jan 7, 2018

SparkyChick said:
Just looked at the image of the wiring diagram which I'm guessing is inside the boiler cavity.... did anyone else pickup the fact it appears to have a fuse in both the line and neutral? Or am I misreading it?

And as an aside, whatever cable you use to connect to the boiler, it should be heat resistant, and I agree with @Madocks . I'd use a five core HR flex.

I remember wiring these boilers about ten years ago and it had a fuse in neutral then.

Spunkywads26 · Jan 8, 2018

I've just done this at my house and can confirm that your connections are correct.

As I've installed my receiver next to the boiler I just ran 3c HR flex and sleeved the g/y core with brown for the switch live. The receiver does not require an earth and my flex is all visible (in mini trunking inside a cupboard) along its length.

The missus loves the Hive especially as it talks to Alexa.

Hive single channel receiver wiring

Jamie'

-

Andy-1960

-

buzzlightyear

-

Madocks

-

SparkyChick

Toneyz

Spunkywads26

-

News and Offers from Sponsors

Similar threads

OFFICIAL SPONSORS

YOUR Unread Posts