looks like they are turning people away who arnt scheme or part p registered, i had a leaflet through the door and tried to apply for a trade account only to be told i wasnt qualified enough, is this a turning point for wholesalers?
DB keys? i had a bunch of keys for merlin, hager and other boards that were in my bag when it was nicked, iv built these up over the last couple of years and were invaluable. Have checked ebay but can only find panel and service keys.
Rob
as above, has been asked to quote and install a UPS device for a security shutter at my local doctors surgery. Problem they have is they are looked out if theres a power cut as there is no manual crank.
ideas please
voltsticks are S***, i got a kewtech one and it glows when im 30 cms away from the source, best off using an approved tester and putting it between the casing and a good earth.
Rob
did a call out today to an old lady who had a problem on her lighting circuit, traced to fault to the extractor in the bathroom, i disconnected it and made the connections safe, its fubar and needs replacing, this is where im stuck, shes asked my to replace it at the end of the week but im not...
Noise IndicationThe symbol is displayed when excessive noise caused by otherequipment exists on the circuit under test. This noise can effect theaccuracy of the loop measurement. The operator is advised to repeat themeasurement or, if the noise symbol continually appears, investigate thecause
Its the noise symbol, it means there is interference on the circuit, I will did out my megger guide and give you done more info later
Sent from my GT-P1000 using Tapatalk
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc