Search results | Page 2

Search results

  1. M

    extractor fan issues (as in, it doesn't work very well)

    hi what you need to remember with any fan is the ducting, air will travel along the edge walls of the ducting the smoother the better. when the fan pushes the air through the ducting any ridge or obstruction will create system pressure, air being pushed through ducting tends to roll along the...
  2. M

    Sensor to detect when a light is turned on

    hi use to install a lot of immersun units few years ago might be worth having a look at using something like one of these although these were used for monitoring PV going back to the grid & then turning on an Immersion heater, might be able to adapt something like this using the current sensor...
  3. M

    Cert says rewire of property

    well when I have completed the testing of this little beauty I will post up the results, just so can compare the results against each other, obviously some things could have occurred over 7 years but in the whole should get like for like results if it was tested properly, we shall see. got the...
  4. M

    Cert says rewire of property

    just on with the new owner now, going in for a periodic inspection report & then a new consumer unit, as mentioned when I undo that pile of sh.t I may as well start again with new board & slightly bigger board to fit in circuits properly & a little extra room for a later date.
  5. M

    Cert says rewire of property

    2010 just having more in depth look now just to see more crap, got ZE 0.17 but for PFC we have a LIM
  6. TEST RESULTS.jpg

    TEST RESULTS.jpg

  7. M

    Cert says rewire of property

    Hi All m8 just bought a new house (not brand new) electrical certificate & new consumer unit for the property, certificate actually says full rewire he asked me about adding extra sockets & doing some kitchen works by my company. asked him to send over a picture of the consumer unit & test...
  8. db full rewire.jpg

    db full rewire.jpg

  9. M

    Some advice regarding 125mm hole for cooker hood fan please?

    lucky these days from what i have seen drill pilot hole, drill in 1" then club hammer, think it is in case they loose to many diamonds or is it too much time i am not sure maybe my age.
  10. M

    Some advice regarding 125mm hole for cooker hood fan please?

    220 x 90 mm is approx 6" 204 x 60mm is approx 5"
  11. M

    What are the basicas of fire alarm install rules... really

    two places booked on a course in October, 3 parts FIA design, install & Commission, although we don't do the design work or the commissioning of the fire alarm system we have this worked undertaken for the company, company we use has over 20 years worth of experience in the field invaluable. we...
  12. M

    Solar PV RISO query. Is 106 ohms bad?

    Hi Gavin Check this page By SMA Insulation Resistance (Riso) of Non-Galvanically Isolated PV Plants with SUNNY MINI CENTRAL 9000TL/10000TL/11000TL
  13. M

    3 position switch ; ON-OFF-ON

    have used several wireless units, one with outside box & antenna other lightwave switch & relay works well.
  14. M

    Another company has my name

    had a new business all set a while back just about to trade went to see trademark lawyer to see about trademarking the name & found out someone had it & who had it Centrica, broke my heart about 50 boxes of printing had to be disposed of. but a least we did not trade.
  15. M

    No RCD on entire installation

    & if for a server I would think twice about RCD protection as above post #42, I would tend to run in a new circuit for server & clean earth.
  16. M

    No RCD on entire installation

    if you look at the work you have undertaken on 3 sockets I would go for RCD protection local to the work you have undertaken, after testing the circuit you have joined on to. the reason for this if you put an upstream RCD in circuit & there is a problem on equipment it could trip & you could be...
  17. M

    Intermittent disturbance on Sunny Boy inverter

    Just just about to say same thing from the above posts it is clearly stated in the install instructions set country of origin codes
  18. M

    Shared circuit for Solar PV & Outbuilding.

    I would be very careful unless you put a warning notice at main consumer unit, who would know about this connection outside in waterproof box. How far away is the consumer unit can you not just run back to that location & leave the solar as it is or is to far away ?
  19. M

    Shared circuit for Solar PV & Outbuilding.

    I would not connect the PV system to the same supply! you could safely isolate the AC isolator at consumer unit but the system is still a generator & will not be isolated completely, DC side will still be live & going into the micro inverter & although the micro inverter requires AC power to...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top