Absolutely loads of cables on ebay in various lengths.
Look at this on eBay 3m Long IEC Kettle Lead Power Cable 3 Pin UK Plug PC Monitor C13 Cord - http://www.ebay.co.uk/itm/371886492718
I remember my dad buying a load of Pioneer hi-fi separates in Germany, shipped them over here, bought some...
Why do they want them in the cupboards so you then either have to chop the appliance fitted plug off voiding any warranty or drill a big hole in the side of the cabinet to pass the plug through?
I prefer my sockets behind the appliances with switched fused spurs with neons above. No issues with...
While youre waiting for sensible advice, slightly off topic but good for a laugh. This always gets shown on our fire marshall training days.
Best Fire Alarm Drill Training Video -
How not to do it!
To simplify it for you, the red coming into the metal box that goes to "common" is your permanent live. When you flick the switch it makes the contact so the power can go back out through the other red in the "1 way" terminal to the light or fan. The small red cable on picture 2 in both commons...
If you are a spark you might get more help over in the Electrical Forum rather than the DIY forum.
There are some really helpful people on here but also plenty of wind up merchants too!
Electrical Forum - http://www.electriciansforums.co.uk/forums/electrical-forum.15/
As well as what you mentioned why would you also tile around the cables rather than chasing them in and tiling over????:confused:
Poor job all round by the look of it. I bet there was plenty more you could have listed through the property if thats the standard of work they are happy with.
In this case all i am doing is removing an existing extension of the 2.5mm ring to replace it with new to allow for sockets where we actually want them before the 2 bedrooms are replastered.
The original cables were buried in insulation in places, not clipped to joists. In other areas they were...
I bet that could get expensive. If the fella isnt happy when he comes to to connect and test then i will put that idea to him. I would need a good few lengths though! What do they do with regards to cable runs in new builds with all that insulation, anyone know? Ive read that it is not an issue...
I bet that could get expensive. If the fella isnt happy when he comes to to connect and test then i will put that idea to him. I would need a good few lengths! Im hoping it will be fine as is though.
What do they do with regards to cable runs in new builds with all that insulation, anyone know...
Is this tamper issue sorted now? Ive fitted 4 of these in my past houses and have another sat here to go in current house. The only time ive had a tamper issue was on the bell box wall reed switch. I ended up looping it out, probably a faulty switch.
I cant remember the symptoms (showing...
1 and 3 are fine Tel but its 2 thats always going to be the issue as cables have to go under insulation at some point no matter how they are run. They are all clipped to the ceiling joists, timbers and walls rather than just laid across the plasterboard so that should help with the potential...
Thanks for the reply Mark. I shouldve just got in the loft before starting this thread. A very considerate builder fixed timber spanning the joists under the perlin that is not in useable space. Ive clipped all cables along the sides of ceiling joists and gable walls where needed and along the...
Im ripping all that section out. The two rooms are an old extension on the bungalow, the ring was extended to provide outlets to the extension rooms. Im disconnecting at the jb's where they spliced in to isolate the rooms and then running all new cable to new socket positions and back to the...
Ha. Never mind. I will give them a ring in the morning. Usually a helpful lot on here, I guess i just picked the wrong time of day today.
Oh well. Goodnight.
Ha. How did I know i was going to get an answer like that.
No, I havent yet. Im first fixing with a local firm making the connections and doing testing. I just like to get as much info as i can on any work i am involved in as ive found many differing opinions in the past across multiple trades...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc