Hi
Have a Parker Integrator 690 series AC VFD drive. cannot take the wires out of push terminals.
Any ideas how to take the wires out? Tried screw driver etc but not sure how they will come out.
Pic attached
Board went completely dead first, stone dead. Haven’t checked motor winding. Wonder why the original board totally died. Orange transformers just leaked probably due to over current. See picture
Motor spec attached.
The board went dead all of sudden. Transformers blown. New board comes on but when PB is pressed the Drive cuts the power to motor. And then will have to switch off the drive and switch back on for reset.
Could it be field problem in motor? What tests can be done
Dear members,
can you please assist.
As soon as start PB is pressed, the drive cuts off immediately and goes to Error mode. We then have to switch off the drive to reset it. We had the newdrive board put in recently. Could it be problem with the motor rather than drive? anything we can look at...
Dear members,
Facing problem with KTK mentor drive. Ran the drive with motor and after few minutes it just went dead. Opened the drive board and saw three Timonta Tansformers leaking orange fluid on the board.
Sent the drive for repair. The drive was ok before so what could have gone wrong as I...
@Spoon no it’s not so much about safety. Though I understand your concerns. Brass Bolts are there to free the pressure should the need arise. Trouble is this additional mechanism was installed by the last chap not by the manufacture of the machine.
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc