Search results
Click here to remove these ads

Search results

  1. W

    ☃️ Day 1 - ElectriciansForums.net Advent Calendar! Enter Here!!

    The NYPD choir were singing Galway bay
  2. W

    Hi. Is there a discount code aailable?

    Hi. Is there a discount code aailable?
  4. W

    TT Supply for shed

    Youre right. The state of the installation when I 1st got the call to go there was shocking. a lot has been done to improve it. The new shed with the swa feed underground is a good tidy job. As for the overhead, it was already there. Installed 10yrs ago. Obviously underground is a preferred...
  5. W

    TT Supply for shed

    The bond from the brass nut and bolt was disconnected from the shed's CU whilst testing
  7. W

    TT Supply for shed

    Good! I was expecting a lashing there!ha! Any thoughts on my other issue?
  8. W

    TT Supply for shed

    It was a loop test off the incoming supply in the shed with earth lead of my loop tester connected to the brass nut and bolt which is bolted to the steel work. Should I be carrying out any other tests?
  10. W

    TT Supply for shed

    Exactly my thoughts, a work mate disagreed with my logic so thought id check on here! 1st loop was 10 ohms but still a few girders to bond yet so can only get better! While were at it, I have another issue! Got called to look at a job on another farm last week. A nice new concrete base has...
  11. W

    TT Supply for shed

    hi everyone. currently doing some farm work and require some guidance. i currently have a 16mm t+e overhead cable on a 300ma rcd, going to a CU in an outbuilding with a 30ma RCD main switch. I then have a 10mm SWA cable going to an animal shed, fed off a 32a mcb, protected by the rcd 30ma...
  13. W

    tt supply for shed

    hi everyone. currently doing some farm work and require some guidance. i currently have a 16mm t+e overhead cable on a 300ma rcd, going to a CU in an outbuilding with a 30ma RCD main switch. I then have a 10mm SWA cable going to an animal shed, fed off a 32a mcb, protected by the rcd 30ma main...
  14. W

    70w metal hallide floodlight

    funnily enough, the fluoresecent are fine and just flicker when the pump kicks in, the metal hallides however go off, and unless you turn the power off to them,give it 5 mins to warm down and the re-energise them after,they wont come on!
  16. W

    70w metal hallide floodlight

    haha yes,im from a farming community and know full well how they are when it comes to money!im sure if i changed the supply cable to the shed everything would be fine, but it goes underground, no ducting so it would be a big job!ill try and change the lamps first,but at a tenner a piece,they...
  17. W

    70w metal hallide floodlight

    its whatevers cheapest really.i know,why someone would wire a 2.5mm submain at that distance i dont know, probably why ive been called there and not the guy who installed it!apparantly the supply cable from the house to the shed is warm during the milking times which clearly indicates that its...
  19. W

    70w metal hallide floodlight

    hi everyone!right, got a problem!got called to a milking farm this morning due to 2 metal hallide floodlights not working.there are a number of sheds but this one is the furthest from the consumers unit and is fed by a 2.5mm submain for the floodlights and a twin 4ft fluorescent. problem is when...
  20. W

    Sockets and switches outside wet room

    yes,but any extension leads would be used by the customer and therefore isnt my responsibility,the switch however,is my responsibility.but i understand where your coming from, just doesnt feel right wiring for a switch knowing full well that a shower is so close to it.thanks for your advice!
  22. W

    Sockets and switches outside wet room

    thanks for my 1st reply!haha exactly the point i was bringing up with the boss.but its a grey area as far as he's concerned, surely the switch wouldnt comply?because with the door open its within zone 1. but even though the bedroom itself doesnt contain a bath or shower, the potential risk is...
  23. W

    Sockets and switches outside wet room

    hi. currently working on a extension, which has a bedroom and a adjecent wet room. my problem is that the the shower head and wet floor area is on your left as soon as you enter the room, and the customer wanted a switch outside the wet room to work 2 way with the bedroom lights. which means...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tilers Community
This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
NHS Forums | Forum for NHS Staff and NHS Patients
Back
Top
✖
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock    No Thanks