Hi all,
I'm trying to install a smart WiFi switch in place of my existing light switches, but I'm a bit confused about the wiring. Here's my current setup:
Downstairs switch: Has L1, L2, and COM three times.
Upstairs switch: Has L1, L2, and COM twice (one set is unused).
The smart switch I...
The following dead-end 3-way wiring diagram shows my current setup with the Zooz Zen21, but it's not working. This wiring works fine with a simple standard paddle 3-way switch that doesn't require a neutral wire. However, since the Zooz switch requires a neutral wire, I ran a white wire from the...
Hello,
I'm replacing standard light switches in my hall and landing with touch switches (not smart, just touch on/off) like these from Amazon; Touch Electrical Light Wall Switch - LIVOLO 2023 New Version 1 Gang 3 Way Modern Tempered Glass Panel Single Pole Electrical Lamp Switch with Led...
Hello everyone...
There are a total of 4 cables entering the junction box at the top of the staircase.
Two 12/2 cables are coming in through the top of the box.
One 12/2 cable is coming through the bottom of the box, with a 12/3 cable coming through beside it.
The three 12/2 cables have...
I know this is probably very simple for a lot of you, but I just can't get it to work right right. I've been close, but no cigar. I disconnected the switches because I painted the walls and I can't remember how I had them wired. There are two 3-way switches that control two exterior lights...
Trying to install a Lutron Toggle/Dimmer (TGCL-153PR)
Confused, as the current switch has 3 wires gong to it Black, White, and Red (there is also a ground)
The Red and Black are both ALWAYS HOT and the White becomes HOT when the current switch is turned on.
Which terminals should I attach which...
This weekend I was replacing a hall light fixture in my old home (rewired circa 1980/90's) and noticed the work was done using one of the exposed ground wires as one of the switch leg/loop travelers on a 3-way. Obviously, this is completely wrong and a fire hazard, so I decided to try to rework...
I have a staircase about 25 feet long with two recessed lights (one up top, the other at the bottom). Each light is on its own 3-way switch, which is ridiculous.
I want to combine the lights so that one 3-way switch controls both lights.
I tried to wire it up so that each corresponding wire...
Hi,
Need some help with an odd setup. I have a large room with many lights that i separated into 2 sets. In Box 1 there is the 14/2 power in, 2 regular 3-way switches and 2 14/3 wires out to the box at the other side of the room.
In Box 2 i only was able to put a single gang box so i got a...
I took a light down to put up a new fixture and now the light goes on but the switch doesn’t shut the light off. The power only stays on so I am quite confused. It is a 3 way switch. Both switches will not turn the light off. The wiring “appears” to be 14/2 to fixture and 14/2 out of fixture...
I have a couple of lights on a 3-way circuit and I want to rewire them with motion sensor outlets and have them in parallel. This way, if either sensor activates, the light will be on.
I am seeking guidance on the right way to do this. I have read a bit on 3-way wiring and it looks like there...
Hello everyone. Thank you in advance for any help you can provide.
I tried installing a dimmer to a 3-way circuit. The dimmer has a hard switch and a dimming slide. After installing and turning the power back on, both the dimmer switch and the other (non-dimming) switch were able to...
I installed a Leviton smart switch in a 3-way circuit and the corresponding coordinating switch in the picture (right switch). The lights function as they should using both switches.
However, I recently was about to install another switch on left side of the box, when I looked at the...
Hi, I'm trying to replace two 3- way switches but there are one too many wires. Can you help?
Each has a red and black wire which I've connected to the bronze screws (as they were before).
There's also a black wire that connects the black(common) screws on both switches.
But then there's an...
As I tried to summarize in the title, I'm having an interesting buzzing issue in a residential home.
Problem: When Lights are turned on, all 3 switches controlling the same load start to buzz, as well as the breaker the lighting circuit is on. Buzzing stops on all devices and the breaker when...
I installed a 3-way Lutron dimmer toggle switch in my basement to control 5 dimmable LED track lights, LED track lights slowly brighten to near 100% when I dim to around 50%. If I dim below roughly 25% brightness then they tend to keep their set level. Initially they worked fine. I installed two...
Hi, really stumped here. I went to replace an overhead light with a ceiling fan/light combo and got it working, but then the rest of the room didn't have power.
The fixture has power to it and then goes to a 3-way switch. In the photo, the middle black is hot and the right one is not...the...
Hi all
I have a dimmable LED light fixture in my kitchen controlled by 3-way switches (neither is a dimmer). Supply goes into Box 1, located by the sundeck door. Box 2 has the other 3-way switch, as well as a single-pole switch for a separate fluorescent fixture. The wires to the lights both...
Hello all
I need help with an electrical issue I think which is coming at my house
I have a 2 three way switch to control a light fixture in my house. Initially the 1 switch was not working so I tried to flip it multiple time, then went to another switch and light started. Again I went to my...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc