Hi, my niece lives in a flat and has a bathroom without a window. There is an extractor fan which packed up and an electrician installed a new one a few weeks ago. That then blew and he came back and said that the extractor wasn't fit for purpose as it is wasn't powerful enough to get rid of all...
Evening all,
Installed many extractors, but this is a first for me.
Customer wants the fan vented out through the soffit, with an inline extractor installed.
Simple enough, until I looked at the gap going into the soffit.
It’s too small to fit a standard 100mm flexi pipe through, and I’ve seen...
I have 16 ceiling spots to be replaced in a room being repurposed as a bathroom. Some will be over a shower, basin and bath hence need to be IP65.
Past experience with sealed unit (ie bulb cannot be replaced) bathroom spots is that they fail long before claimed lifetime and are then difficult...
1964 house old style wiring
Need to wire a extractor fan up
Is it possible to wire the extractor fan to report switch there's 2 red wires in the pull switch both red. one is a permanent live
Can I wire it up to the pull switch some how or do I need to go to the ceiling rose wiring which is in a...
Hi, have an old bathroom fan. Which has two wires the black and red (line and neutral).
The fan has no isolator switch and was powered when the bathroom light came on. When turning the light off, the bathroom fan stopped.
I disconnected the fan wiring from the ceiling rose to clean the fan. Now...
Hi all,
Got an awkward bathroom fan installation in a downstairs flat, concrete ceilings and (some) walls. Bathroom is already fully tiled and 'finished'. Due to the window in the bathroom, it is impossible to get a fan directly out of the one external wall. A window fan is a theoretical option...
Hi,
Buying a replacement extractor fan. It falls into zone one with the room setup. Looking at two fans. One is rated zone 1 one is rated zone 2 and both have ipx4 ratings from what I can see and from wider reading ipx4 is the requirement for zone one and two?
is the ipx rating all the...
Had to remove a led strip from a bathroom today because it’s getting tiled, now the led strip that was there was low voltage but didn’t have anything covering it. I’ve seen the wee aluminium profile things before, is this something that the led strip should be fitted in when in a bathroom? It...
Hi
I'm looking for some advice for adding a time delay on my parent's shower room fan.
My parents had a section of their garage converted into a shower room with toilet. But the builders did something a bit odd. They fitted a pull cord light switch by the door and then a separate pull switch...
HI There,
I would be grateful if you could help me, I have a very long duct between the bathroom and extractor outlet vent and for sometime, the bathroom stream overwhelms the extractor fan so much that I end up having severe condensation and moisture puddles, because it was a new build. They...
I have a socket in by bathroom vanity unit, .75m away from the edge of the bath. The vanity is completely enclosed with a sink on top and doors that, when open, are parallel to the length of the bath.
I hired an electrician to do some work and once he saw the plug in the bathroom, he informed...
I've installed a replacement bathroom extractor fan. Pic on the left is the old one. Pic on right is the new one. Wired the same way but the fan won't work when the bathroom lights are switched on. But if I put a multi meter on the Switched Live & Live terminals, it starts working. Is the fan...
hello all, pardon my ignorance in not employing an electrician, however, im a diy'er whos changing the light switches in my house and came across this unusual wiring for my downstairs loo. its a single light which has a fan which can be isolated as necessary. I ordered all the new chrome light...
Hi folks. Need some help, wanting to add bathroom mirror with built in shaving port but don't want to chop into wall as I can't replace the tiles, don't think they make them anymore. I'm planning on coming off the lighting circuit in bathroom, adding fuse spur and running pvc trunking down to...
Hello. Non-electrician here. Failed an EICR yesterday as the electrician graded my consumer unit C2.
Why C2 and not C3? He didn't say (and still won't). Consumer unit is the same age as the building - dates from 2003. No RCD. But never had any issues. No apparent defects.
Apparently lack of...
I'd like to find a timer switch, in a style that looks alright next to decora light switches, to control a bathroom fan.
The bathroom fan connects to a 120V AC continuous power source. It has a USB plug that connects to a humidity detector, and it has leads that can connect to a switch that...
Hi All
I have recently had a new bathroom mirror installed with a built in LED and Demister that is turned on using a motion sensor.
The mirror works perfectly, except when there is a power cut. When the power is restored, the mirror LED automatically turns on, this is not ideal if we are out...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc