Looking to replace my current generic test leads that are starting to show signs of variable readings. I also find the crocodile clips don't tend to stay on neutral or earth bars very well.
I have an MFT1711 (and a venerable 1552) so need standard 4mm connectors.
The Megger set are expensive...
I have a 20mm steel conduit drop to an accessory box buried in the wall. It was previously used for lighting cables and had 2 x 1.5 t+e and 1 x 1.5 3+e squeezed into it. There is no actual conduit system installed - the conduit simply goes into the loft and ends. There is some kind of rubber...
New induction motor turned up at work today.
The entry options are now 20mm and 45mm.
The previous motor was wired in 5 core, 6mm S/Y, through a 32mm compression gland.
I would prefer to make the S/Y off with a proper cxt gland.
A cxt32 is the size I will need. I am not sure what size the...
I have the following alarm system, but I've just purchased a new Ring alarm bundle that I want to swap it for.
Couple of reasons why I haven't just ripped this out to start over with my new one:
1. The original alarm keypad by my door has a power cable I'd like to use for the new Ring keypad...
I need approximately 170 feet of 6/3 uf-b wire to run from my main panel to a new disconnect for a pool heater. Running conduit is just not possible for me given the obstacles. The best price I found is 1.98/foot from Wire Wire Electric Supply with free shipping. Does anyone have experience with...
Trying to locate a suitable RCBO for a Siemens board with (mostly) 5SX21 breakers in.
They don't seem to make this range any more, though I don't think it can be that old. It rather resembles the older MK breakers and I believe Siemens provided some of the electronics for MK stuff.
Busbar...
Plan to offer installation of EV Chargers, but not interested in using Earth Rods. I can only find two products, Zappi and Podpoint. Are there any others? Who would other EV installers recommend?
Hi all, I'm just wondering what is people's preferred choice of set up with regards to DB's for a TT system within a domestic setting. I know there's different views on this (Type S uprfront etc). Are most people installing dual rcd boards or DP Rcbo's? Just looking for some views on this. Many...
I’m looking for the best method to run a cable from the CCU from the Garage to the 30ma RCD in the Garden.
I am going to order some HiTuff rather than SWA as I can’t get the paving slabs and stones up. Also I’m not sure about drilling into the concrete posts. I have attached some photos for...
Hello, I am in need of a replacement tyre pressure sensor and the below is a bargain price for a OEM part, the best before date on the packaging says 21.01.21, I'm assuming this is the date it should be fitted by right? It contains a lithium battery.
Thanks Lewis
So I’m at a crossroads. I’m 21, and I’ve just applied for a college course but im worried at the end of it I will not be able to get a job as an electricians mate. And I’m worried on how long it will take.
I was looking at the apprenticeship route, but it’ll leave me on £4.15 an hour and...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc