block | Page 2 | ElectriciansForums.net Est.2006 | Free Electrical Advice Forum

block

  1. D

    Henley Block inside fuse box ...:)

    scroll forward to about the 10 min mark , genius.. :)
  2. C

    UF cable though block wall

    I am replacing some electrical outlets in the basement of my home. The previous wiring was 12 gauge 2 conductor only, with no ground. I am planning to run 12 gauge 2 conductor with ground. I would think that the best wire to use inside the block wall would be the grey wire that is rated for...
  3. sibbits

    old timey bending block

    any one know how to make/use an old school wooden conduit bending plank?
  4. D

    Does anyone still use connector block..?

    I still have loads of 5a & 15a screw connector block strips , I use the odd bit occasionally just wondered if anyone else still buys & uses connector block or is it all Wagos now ?
  5. Leesparkykent

    Submains/distribution circuits on block of flats

    Hi all....I’ve got a block of flats I’m doing the M&E on. It’s just design stages atm and there is a basement where the central boiler system and switch room is going. The problem I’m having here is that this is the far left hand side of the building and the riser is pretty central. Far from...
  6. V

    CAN I CONNECT 10mm2 IN TO A 25mm2 Henley block?

    Hi there. I’m installing a secondary mini consumer box with a 40 amp RCBO. The main tail that comes from the meter is 25mm2 and goes in to a Henley block and then another set of 25mm2 tails come out from this and go in to the main consumer unit of the house. Mains service fuse is rated at...
  7. W

    Is connector block allowed inside a fuse board?

    Hi all, wondering if someone can clarify this or refer me to a regulation regarding using connector block inside a Consumer Unit, I have some cables that are being moved the the RCD section of the CU but are too short and there is no practical way to get more length without making a mess. I’ve...
  8. R

    Earth bonding to gas in a large block of flats

    Hi, just doing an inspection on a large block of flats. All the gas metre are in a single store cupboard on the basement floor. All are 10mm bonded there within 600mm. There is no earth bonding to the pipes entering the flats themselves. Is additional bonding required within each of the flats ie...
  9. L

    New kid on the block.

    Hi folks, Sorry for the late introduction. Joined up about 1mth ago. Had been stocking this site for a while. Background, 16th edition from early 90's (1990 NOT 1890), didn't enjoy the work at the time (didn't get on with my employer - felt like his personal slave - the joys of me being...
  10. M

    Wiring the terminal block on a Login oven

    I'm trying to wire up a new Logik oven and it has a non-standard terminal block, much smaller than that on the oven I just replaced and all the YouTube videos I could find. It looks like you just screw the electrical wires in directly. So, I guess I should remove the connectors and screw the...
  11. Mike Johnson

    Earth terminal block

    Does anyone know where I can get an earth terminal block like this in the UK: https://www.leroymerlin.fr/v3/p/produits/repartiteur-de-terre-p-40-mm-michaud-e1401450424
  12. 1Justin

    Hager part KRN190 neutral connecting block

    Who's familiar with Hager KRN190? It's called a "neutral connecting block" by Hager with no further info. This seems a maybe misnomer, but I have never seen one in the flesh.. I'm assuming it would have a lower terminal spaced to fit a standard Hager busbar prong if it were fitted like an MCB...
  13. S

    Help replacing an old pendant to IKEA pendant with connector block

    Hi everyone, new here. Sorry if this may have been posted before but here goes.. I've been asked by a family member to fit a new light fixture from an old ceiling rose pendant to this ikea one.. SKURUP Pendant lamp - black - IKEA -...
    • Stevo12
    • Thread
    • block connector ikea old pendant replacing
    • Replies: 10
    • Forum: Lighting Forum
  14. dc_8769

    Panel heater wiring in block of flats

    Hi, new poster here so hopefully I've put this in the right place! I live in a large block of flats and have noticed that none of the panel heaters or heating rails in my flat are working. I believe they are all on the same circuit, as my consumer unit has a switch for heaters- this hasn't been...
  15. D

    Henley block alternative?

    Hello peoples ? I am installing an additional consumer unit to an installation. I’m going to stack them one above the other, normally I would use the henley blocks but I was wondering if there is an alternate solution to this? Is there any way Split the supply cables within the CU’s? I know...
  16. E

    Wiring terminal block for induction hob

    Hello...I need to rewire a terminal block for zanussi induction hob zei6840fbv Can someone help please. ImGe attached
  17. cliffed

    School block Swa supply

    What code would you give for a Swa supply 3p/N,95mm. Supplies remote school block,2 storey,no main earth conductor,using sheath,the main earth bonding originates from this Swa,for this block,@ Main Panel board,& is 16 mm The main earth @ origin is 120mm,Main bonding 50mm. Cheers
  18. T

    Pricing a large block of flats

    Any one on here have experience of pricing or working on large blocks of flats? I have a block of 30 to price for an need some advice! Thanks
  19. Barnaby Stedman

    Running under block & beam

    Has anyone had any experience with running rfc's under a block and beam floor on a hardcore base?
  20. C

    PME supply block of flats

    Hello Guys I have a 200a 3-phase supply PME bolted to a large ryefield panel, the ryefiled panel then supplies 14 flats within the same building. Each flat is supplied a 63a from ryefild via meters in the form of a 16mm 3core SWA cable. The furthest away is flat 14 at around 25 meters, seeing...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Back
Top