Hello, hope you guys can shed some light on recent incident.
Recently I installed a heating system to a property in France that consists of a pellet boiler with vacuum feed, solar thermal, UFH etc... The system was all up and running nicely. A few months later , an electrician was working on...
Hi all I've recently fitted a underfloor heating system using heatmiser controls and a Worcester Bosch oil system boiler boiler. On the heatmiser wiring center I have an in and out boiler enable volt free, and at the boiler I have L N E . Please see attached photos.
Thanks James
Hi all I've recently fitted a underfloor heating system using heatmiser controls and a Worcester Bosch oil system boiler but I'm a bit unsure as to what connection to make to the boiler. On the heatmiser wiring center I have an in and out boiler enable volt free, and at the boiler I have L N E...
Can anyone help, I have looked at a central heating pump for my brother in law (who is a plumber!?:-) it is an HRM oil fired boiler, the problem is that the circulation pump is permanently on, there is underfloor heating with the system, the wiring is shocking and I will probably have to re wire...
Due to illness I've fallen behind with my home renovation plans. I had mounted my new combi boiler (Sabre HE) 6 years ago but as yet have not plumbed or wired up any of the supplies to it. I plan to start running in the pipework soon.
Is there anything I should be worried about given the...
Good morning all,
I trust you are well.
I am looking for an electrician who can help install 2 x Tado Smart Thermostats and their extension kit in a residential property in Kent.
The problem is, I bought the products directly from Tado and purchased their installation service but Tado turned...
Hi everyone. Hoping someone can help. I'm using a recently qualified electrician to carry out the following work but he wants me to tell him what I want and supply parts for wiring to lpg boiler/thermal store. I would like to have two pipe thermostats on flow and return to store (as close as...
Good morning guys and girls
I have attended a kitchen rewire this morning to test a install buy a 3rd party.
The boiler spur is directly above the draining board I'm quite sure this shouldn't be the case. I've been told by the installer that "it's fine it's rcd protected" is this just waffle to...
Hi All
Got an issue with a OJ WLM2 Hydronic Master Underfloor Heating Wiring Centre.
When you activate one zone using the room thermostats, the system kicks in and starts heating up the boiler but within 10 minuets the system shuts down!
For reference:
Electric Boiler 13KW (single phase) with...
Good Morning Forum.
I have an issue with a customers Heatrea Sadia Electromax Combi Boiler, i was wondering if any one had much dealings with fault finding on those units.
Im based in Aberdeen, going on 19 years self employed up here. 6 years ago we installed one of these Electromax Combi...
Hello. I'm just looking for a bit of advice.
I had a new boiler fitted a few months ago. An electrician came and wired it up and left me a Minor Electrical Installation Works certificate.
ive just had a plumber round to check the work and he says the electrician has wired the boiler from the...
I have been asked to wire up a heating system for someone, never done this kind before as nearly every man & his dog has gas or oil boilers these days apart from my client who seems to be going back in time! He has a woodburning stove which he is going to use to heat the radiators in the house...
Hi Fellas, I've had a sniff around the forum and can't find a conclusive answer..
I've had Hive installed a couple of years ago and I'm starting to question if it's wired correctly or if it's just how my system works since I now know a few people who have it installed.
When I call CH, I have...
Hi
I’m thinking of switching to a Hive 2 thermostat …..
I currently have a very old SUNVIC TLX thermostat which from what I can work out is only connected to the oil central heating circulating pump which it turns on and off..
There is also a thermostat on the electric hot water cylinder...
Hi, hope somebody can help. I am currently wiring a new wet underfloor heating system for builder. The plumber has fitted a 2 port valve and the pump that is part of the manifold.
The existing system is a y plan.
I was going to leave existing system how it is and fit a wireless programmable stat...
Can anyone help us with a problem? Since the summer one of our RCDs has been tripping every night at the same time (22:52 before the clocks went back, 21:52 ever since). There are two RCDs in the switch board: the one that trips has an outside workshop, upstairs sockets, downstairs lighting and...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc