I have had my kitchen rewired and plastered. I have had a 6mm t+e on a dedicated 32a circuit for a 60cm electric cooker. In hindsight, had i known at the time, i would have asked for a10mm cable to future proof the installation. The cables run from the consumer unit in the attached garage, into...
I am a retired electrician and I've been out of the game for a while. My son asked me a question the other day and I wasn't too sure how to answer it so thought you lot might.
He wants to use rails to supply 5 modules, each module will have 40 small actuators that operate at 24VDC at 0.9As...
Hi, recently moved into 30 year old home. We were renovating it for a few months and didn't notice this issue. 3-4 times over last month the power has gone out to the entire home, without flipping any circuits. When we've been home for it (twice) it has only lasted a few seconds. I'm yet to ask...
Hello,
I'm replacing standard light switches in my hall and landing with touch switches (not smart, just touch on/off) like these from Amazon; Touch Electrical Light Wall Switch - LIVOLO 2023 New Version 1 Gang 3 Way Modern Tempered Glass Panel Single Pole Electrical Lamp Switch with Led...
hi all
come across a new build commercial office where radial circuits feeding electrak power track was protected by 32A RCBO at dist board and the electrak tap off leads terminated into RCD under desk sockets
why install RCD sockets when circuit is protected by 32A RCBO
is this install correct...
Hi everyone
I bought the following device for the purpose of inspection and testing of DPs and its connecions:
https://www.ebay.com/itm/266252623696
I used this device to inspect a building where i work and with the help of an engineer working on that location we were able to find that a...
As I've mainly done site work and moved into domestic recently, I'm a bit rusty on stuff like this, but if I'm adding a loft PIV unit to an existing lighting circuit via an unswitched fused spur, if the lighting circuit has no RCD protection am I allowed to install it?
Same question for if...
DIY query
Have narrowed down the source of an occasional trip to one light circuit which is a varilight v-pro master dimmer slave set up.
This is one of 5 LED, low total wattage light circuits connected to one 6A RCBO breaker (so the issue could be a short or a ground leak). Zero problems...
Please advise what I should test / check next.
My usual qualified electrician who did all of the work here is in Ireland for 4 weeks and not contactable. I need to fix this asap. Ring final circuit tripping. I am not clueless and I have some test gear. Can fully isolate the supply with an...
Hi everyone. The title should sound crazy enough, but it's what happening in my 72-years old home we've purchased 2 years ago.
I found the crazy wiring when I was just troubleshooting on a lighting which has been flickering, and finally completely failed recently. I recognized the lighting is...
Hi folks,
Quick query for this still practicing regarding bill payment for a job not complete.
My partner recently employed an electrician to do some simple work, post a a bathroom re-fit. Extractor, lighting fit along with resolving a problem relating to switching of lights in hallway. Whilst...
Hi,
Just been scratching my head about this one and wonder if I've missed anything.
A few weeks ago I installed a new circuit for a 3kw oven and a 950W microwave. Ran the circuit in 6mm T&E clipped direct on a 40A RCBO.
Customer has reported that on maybe three or four occasions the RCBO...
Hi,
So I'm trying to understand what's going on with my off-peak electricity supply, as something's wrong with it and I'm trying to determine if it's the responsibility of my energy supplier or I need to get an electrician out to take a look.
Here are some pics:
I live in a flat...
Bob 1 57434
Thread
appreciated
circuit
economy
economy 7
help
problems
Hi everyone.
I should start by saying I'm not sure I'm in the right place here (this isn't a householder issue - I'm making a Ghostbusters backpack for my son!), and that I have no knowledge at all of electrical circuits.
I have a simple circuit with 3aaa batteries powering a string of static...
Hi guys
I have some industrial lighting circuits to wire in a workshop and was after some fresh ideas/suggestions as to how i could best do this.
Have done a few of these before and in the past i have sometimes run radials in SWA cable to single gang socket outlets. The High Bay LED lighting...
We have one room that seems to have lost most of its power last night. One of the outlets in the rooms has a power strip plugged in that powers the tv and video games, but we flip it off when not in use to save power. Last night, when I flipped the power strip on, the entire room lost power, but...
Hi everyone, 1st post here. I'm a DIYer looking for some advise please. I've got a blender/mixer from India which has decided to pack up. I've narrowed the problem down to a circuit breaker (thermal overload protection switch) I'm not able to find a match on Google or on screwfix, does anybody...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc