connection

  1. I

    C-Tec Panel Auto Door Connection

    Evening all, Can anyone tell me if this panel has connections for a cable to signal an automatic sliding door to automatically open when the system has alarmed? Cant see to see any mention of it in the document below...
  2. T

    Cooker hood and bathroom fan connection via duel appliance outlet plate.

    I wish to install a bathroom extractot and cooker hood from an existing 32 amp 6mm cable . I intend to use a duel applliance outlet plate to split into two 6mm cables running to seperate 3amp FCU's from there 1mm cables to all parts that follow . See diagram . Is this in line withs regs. Thanks .
  3. T

    2 way gang lighting connection wirring issue.

    How can i wire up this design so that i can have a two way lighting for the landing and also switch the bathroom.light on. Both cables are 3 core and earth.
  4. A

    Rcd fused connection unit

    Hi all, could I have opinions on the use of rcd fused please. Customer has old 3036 at the front of the house. They want a couple points on there new decking for festoon type lighting switch from inside. There is a t and e switch fed outside light already so I'm thinking of coming off this to an...
  5. S

    Electrical connection & cable for replacement oven

    Greetings everyone. My first post here, having read a similar thread, I understand that following the manufacturers guidance is all important. So, if anyone could help please, here's my question : I am replacing a single fan oven currently connected using a 13A plug into a socket which is...
  6. B

    UK Anybody know what a good standard TT connection point should look like? Is this dangerous?

    Would this TT connection point be at the stage where it needs repair? Under UKPN control.
  7. E

    Generator Connection

    Hi - looking for some guidance for my off-the-grid cabin. I’m powering the main panel with 30amp generator plug. What wire do I use from the 30amp inlet plug to the main service for the panel? 10/3? Also, I’m on bedrock and cannot drive a grounding rod into soil. How can I ground the panel...
  8. D

    Oven with 13a plug top

    Been asked to fit new oven , which comes with a 13a plugtop , there is no socket close to plug into , if i cut plug off and connect into cooker unit connection behind cooker , do i have to adjust the 30a cooker unit fuse.
    • daveboy
    • Thread
    • asked comes connection cooker fit new oven plate plug small sockets unit
    • Replies: 18
    • Forum: UK Electrical Forum
  9. S

    Moving Connection point and meter

    Hi Guy, I’ve contacted my DNO Scottish power and they’ve quoted me a price of £760 to move my connection point and meter. I seem to be doing most of the work with them pretty much terminating it. I’ve been looking for someone else to do the work as I’ve believe it’s ‘contestable’ but I’m...
  10. H

    Underfloor heating wiring connection plug

    Ea
  11. J

    Loose connection

    Just one to clear up the nonsense I’ve been told that when a loose connection happens it causes a high resistance joint causing voltage drop and heating of the joint. My question is will this cause a breaker to trip. I’ve been told before that due to the added resistance the circuit then draws...
  12. Kamikase

    need an expert opinion on this connection

    Hi All, I am trying to understand what is going on with my under the cupboard led lights. This connection was already like this when I bought the house where for some reason one light is working fine where but the other 2 lights have the same 4 leds working fine (the other 15 lit up but not as...
  13. A

    UK 13A fuse kitchen grid switch, connection confusion

    Hello, I was about to replace the old tatty 8 gang grid switches in my kitchen with some new Varilight ones. The only problem I have is that the two old 13A fuse modules had 3 connections. There was a live wire going into the top terminal and then a single yellow into one of the bottom ones and...
  14. P

    UK Connection issue

    Elderly DIY guy replacing a Manrose extractor fan.House wiring is copper cored red/black/green and yellow and was apparently OK for old extractor but modern replacement needs connection to terminals marked ;- Neutral supply Switched live supply Permanent live supply My question is which goes...
  15. J

    New bath fan install to 4 wire connection

    Installing a bath fan. Connecting original 4 wire to new 3 wire fixture. What did I do wrong? (Capped red from supply side. Connected 2 grounds from fixture to supply.) Both red and black read hot when switch is on.
  16. A

    32amp socket connection for temporary cabin

    Can anybody help please.....I need to connect a cabin electrics to the house, appreciate normally long term this would be via fuse board direct, however I just wish to connect to the house using 13amp plug. The minimum draw from the cabin is 20amps, if I used a split socket 32amp to twin 13amp...
  17. R

    Electric Hob and Oven connection, one supply.

    Installation of a cooker in a renovated property, electric oven and a separate induction hob. The hob was to be gas - now with the induction hob, can it be fed from the oven radial via a dual wall outlet? The radial from the Consumer unit is 10mm T + E. The local isolation requirement can be met...
  18. K

    Connection above or below terminal screw plate

    Does a wire attaching to a screw terminal on a standard receptacle outlet go over or under the little brass movable plate, please? Thanks
    • Kitkat
    • Thread
    • below brass connection little outlet plate please screw screwfix standard terminal under wire
    • Replies: 4
    • Forum: UK Electrical Forum
  19. SJD

    "Safety Electrical Connection" metal labels

    Does anyone know a source of just the metal labels that are attached at earth clamps? Every time I need to replace a missing label, I'm taking a label from a new clamp, and throwing the clamp away, which seems a bit wasteful. I'd love to buy a bag/box of 50 or 100 of the metal labels.
  20. Pip

    UK Earth Rod Connection

    Is this an acceptable connection to an earth rod? And is the water bond really necessary? (New duel RCD board recently fitted)
Best EV Chargers
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Daily, weekly or monthly email

Receive a daily, weekly, or monthly email containing a digest of new and recently updated threads.
UK Tiling Forum | Tilers Forums
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Electrician Tips from Professional Electricians
JBOD Forums: a forum for JBOD storage server advice
JBOD Suppliers: JBOD Storage Server Supplies
Back
Top