Hi Guys,
I am just changing my plug top oven over & gas hob and noticed the following:
32AMP Breaker > 6MM Cable > Cooker Switch 45a > 4mm cable > Double Socket which powers both.
13a Plug Top Oven replacing the previous same plug top. Gas Hob and just powers the igniter.
Is this right or do...
The photo shows a cooker hob ignition switch unit from a Neff/Bosch hob. One of the switches has failed. The issue was caused I think by ingress of liquid. I have dried the unit as well as I can. A replacement unit costs over £40. Has anyone ever opened one of these to repair it? I am reluctant...
I have just bought a new cooker hob which has 4 wires however my connection points only has 3 connectors do I connect 2 of these wires together in order for it to function properly or would I need to buy a new connection point with 4 pins on. I will more than likely have to get an electrician in...
Hi,
I would appreciate some views on the following issue I have.
The Cooker radial in a house has been wired in 2.5mm T&E, to save the expense of a larger cable. Without boring with the detail, I cannot pull out and replace the existing cable, nor wire in a new 32A circuit using another...
Hi iv just fitted a cooker hob to a newly fitted kitchen, the junction box for the hob and oven was already there and the cooker switch too, in other words it was all there and ready to go it just needed a heat resistant flex for the hob, however when i lifted the panel over the terminals to...
Hello,
tried posting this in the DIY forum, but couldn't see that post thread button.
My Problem:
I have bought a new extractor hob, now the previous one didn't work and when I took out the old one I saw that the fuse(3 amp) was gone, which I changed now.
When I put the brown & blue wire in...
Hello there
I need to move an existing combined cooker switch/ 13 A socket in a new kitchen, as the hob will be directly below the existing location.
There is not enough 6mm cable to allow me to move it around 50cm to the left of existing position.
To avoid replacing the whole 6mm cable, one...
I have a rangemaster 110 cooker and 2 of the hobs do not spark when pressing the button at the front of the cooker. The other 2 hobs spark and light ok.
I have replaced the electrodes with new ones purchased from espares website.
Rangemaster Hotplate Electrode for Classic Deluxe 110
However...
Hi
Looking at IEE's guide to building regs in 5.2 Kitchens: I understand that sockets should be > 300mm from a sink (5.2.2 iv) and cooker switches should not be over the hob (5.2.2 ii) but only the illustration shows 300mm for the cooker switch nothing in the text. Would you think a Napit...
I just recieved yet another phone call from a previous customer who has a seperate cooker hob and every 6 months or i have to replace hob due to this tripping one 30ma rcd from a split 17th edition board. I cant put it on a non rcd protected way due to a socket outlet in the cooker switch. My...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc