core

  1. T

    Cat 6 solid core for rj45 male ends

    Hi , i was told by an IT guy in a place that i was working that solid core cat 6 shouldn't be used with male rj45 ends and the cat 6 solid core ends should be terminated to a female end and pre made patch leads(apparently they are mad with stranded cable) should then be used to connect to...
  2. B

    Wiring an Optima G4 Alarm panel to a Reson8 bell box using existing 4 core cable

    I am replacing an existing old bell box with a Reson 8 bell box 8EP420. My alarm panel is a Optima G4. They are connected via a 4 core cable. The existing panel wiring is as follows: Panel Bell box Strobe+ (no connection) A link between T and A Strobe- (yellow)...
    • BernieA
    • Thread
    • 4 core accenta alarm bell box cable core existing optima panel reson 8 using wiring
    • Replies: 2
    • Forum: DIY Electrical Advice
  3. T

    Core drill dilemma

    So my dewalts diamond falling apart, literally the fronts falling off, and I can't get the chuck off to see whats going on. Annoying as it's only about 3 years old. These days tools don't seem worth/designed for putting in for repair as the costs Vs new don't stack. Normally I'd just chuck $$$...
  4. C

    Best method to calculate 4 core SWA current rating for two pairs of 1PH line conductors

    Hi, I have a Victron Multiplus-II 5kVA inverter/charger with Pylontech US5000 batteries installed in my house along with a 6.8kWp PV array and associated charge controllers. This installation has full DNO G99 approval and was installed to BS7671 and has been running great for about 18 months...
  5. MaintenanceSpark

    Three Core & Earth

    Silly question I'm sure, but I'll ask anyway. On a 2 way lighting circuit the black and grey conductors get sleeved brown to show they're line conductors and I'd like to know why as black and grey are line conductor colours anyway so surely if the grey isn't sleeved blue it's a line and if the...
  6. V

    Led floodlight to exsisting 4 core flex

    Am fitting a new pir led floodlight . The exsisting light is connected to 4 core round flexible cable, core colours green/yellow, blue, brown and black . Should i use the green/yellow , blue and brown and just terminate the black Many thanks
  7. yowie7860

    Solid Core Earth in multicore

    So, according to AS 3000 5.3.2 Earthing conductor material and type 5.3.2.1 Conductor material 5.3.2.1.1 Copper conductors Copper earthing conductors shall be of high conductivity copper and shall be in the form of— (a) stranded conductors; (b) circular braided conductors; or (c) solid...
  8. lyeuhm

    [UK] - 2 Core Red Black Assistance

    Hey, I have a shed in my garden that was built and wired up by my granddad a lonnng time ago and it currently uses 2 core/twin and earth cable but the cable is red and black - I believe it's 2.5mm as it's for two plug sockets and a couple of lights (existing). I'm wanting to come off the...
  9. W

    If you have 3 single core cables in conduit for a singular circuit would this be classed as bunched?

    Hi there, I'm Currently doing my design calcs for my college project and doing the actual Zs calculation. Formula is Zs= Ze (or Zdb) + (R1+R2) Then for (R1+R2) you find the (R1 +R2) per metre value in the On site guide appendix i - i1 , which for me line and cpc are both 1mm so its 36.20 . I...
  10. J

    Need a little help, can I add a second PIR with a single core line in (live)

    Will this work?
    • Johnny M
    • Thread
    • core help little live pir second single single core
    • Replies: 4
    • Forum: Lighting Forum
  11. A

    3 core and earth on a light fitting

    Good evening. My son in law has moved into a 5 year old house with a conservatory. There is a 3 core and earth lighting cable poked through from the house into the conservatory which has never been attached to a light fitting. There is only ONE switch serving this light NOT two. My question is...
  12. R

    I am designing a wall light with 3 core 0.75mm cable leads.

    I am designing a wall light . Can the cable leads from the fitting be connected to the mains wiring inside the wall cavity or does the connection have to be within a terminal housing as part of the fitting?
  13. J

    Concentric 2 core cable used after meter and main iso

    Completed EICR on flat within block building, Suppliers set up is as follows Within switch room Service head Meter Main iso 2 core concentric cable up to flat 10 meters away Secondary service head TN-CS Consumers DB Im not really sure where the suppliers/ consumers wiring starts/ends with...
  14. G

    Single core cable in conduit terminating outside

    Looking for some advice; I am intending to mount two led downlights on pillars/brick walls either side of the garage door opening. I will drill through the cavity to feed the cable through. There will be a PIR sensor mounted in the middle above the garage door. Internally i wanted to put the...
  15. P

    What cable size and breaker would I need for two extractor fans in a public toilet? 1.5mm 3 core and a 20amp rcbo?

    What size cable for 2 extractor fans in a public toilet?
  16. EastCoastPete

    Lead sheathed 2 core lighting circuits /EIC

    Evening All, I'm changing a CU from rewirable to 6 x RCBO in a Victorian flat. The two lighting circuits are lead sheathed 2 core, they appear physically undamaged though I've yet to test them but is this an automatic EIC fail? The switches and pendants are all plastic. Thanks for any pointers, Pete
  17. L

    Please Help, wiring a switch with a singular 3 core wire

    Hi, im having trouble. I want to wire up some outdoor lights through a smart home plug. They were previously connected to an analouge timer and after removing this ive found that there is one singular wire coming from the lights. this wire has neutral (blue) live (brown) and another black wire...
  18. Q

    Reference method for the old sheathed single core cables run in attic spaces with insulation

    Good morning I am just wondering what reference method is suitable for the old single core sheathed cables if they at some point enter an attic space under insulation.ive had a read through the regs book but still unsure Cheers for any responses Harry
  19. W

    2 core for 4 inch fan wiring

    Hello I’m starting off doing jobs for myself and I’ve come across a bathroom with lack of ventilation ... The fan in place is a 4inch fan tight to the ceiling corner. It’s fed from the light in two core to a isolation switch and transformer in the kitchen behind the fan. Currently it’s fed in...
  20. M

    6 core flex mains and low voltage

    CP electricians supply a 6 core cable from their lighting control boxes that supplies a mains voltage emergency light,, 2 cores of this are 18v dimmable switching. A led lighting company have provided the led lights and drivers that connects to the 6 core flex however their emergency pack and...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Back
Top