I recently bought a bathroom mirror with LED & Bluetooth speakers (from Amazon). There is a double isolated symbol on the back of the mirror yet there is also an earth wire connection. Is this unusual and should it be a cause of concern? It has not been installed yet - just wondering what your...
Performing the PAT inspection on some science equipment and I have found some items that were passed by the previous company that performed it however it failed the earth bond test and has a metal case its a air pump. upon closer inspection, I found that they only have two core wires and have...
Hi, I've got a light with a ceiling rose in the kitchen. While rectifying some faults in the house I came across to the light and measure Neutral to live: 240 volts (which is fine ofc) however when measuring earth to live I'm getting 150 volts. I have checked for any touched wires with my Fluke...
Hello all
Sorry if this has been answered previously.....
Got a light with this earth wire (picture attached). I can see from the instructions (picture attached) where the earth wire is to be screwed into, but what about the other end with the exposed twisted wires? Have I to tape that end to...
Hi, thanks in advance for any advice here please on a safety worry...
My son lives in a rented house and recently got a strong electric shock when he turned on a light switch, he felt it go down his arm and to the floor (bare feet, tiled floor). An emergency electrician came out and found that...
I live in an ex council house in manchester which I imagine was built around the 1940s.
Upon renovating the severely outdated living room, I removed two ceramic wall fitted lights that had switches and were independent to the main light fitting in the room. I didn’t really pay attention to the...
Having just replaced an immersion element with its life expired cable and switch, I'm thinking of replacing the switch (20A double pole) with a smart version so that I can control the hot water from my phone etc.
Both the immersion heater and the current switch have earth terminals, however the...
Hi all, hoping everyone has enjoyed their bank holiday weekend. I hope this post goes in the right place as I've just joined. I'm looking to swap a two way light switch and two double plug sockets from bog standard plastic ones to stainless steel ones, the existing wiring (old colours) has an...
I have accidentally cut a 16 mm earth wire running through my loft. It's in the middle of a 30 metre run. What's the approved/acceptable method of joining the cut ends?
Hi all
I haven’t done much of anything with electrics since secondary school (long time) and hoping someone might just double check what I’m saying isn’t totally wrong!
Im building a keg system for home brew using an old chest feeezer. To regulate the temperature I’m using an ink bird ITC 1000...
Hi everyone,
In a bedroom, I have two single light switches that control one light (one by the bed and one as you come in by the door). I am fitting new stainless steel face plates to them. Did the one by the bed first and that had an earth wire connected to the back box so could fix that to...
for T@E cable, we cover the bare earth wire with a sleeve of green / yellow. Why?
The basic idea is that if there is a fault then the live wire meets with the earth and covering the wire with insulation potentially stops this action in some cases. Is it not better to have the bare wire to...
Hi all
Apologies if it is a stupid question and have been discussed here before.
Generally I always hire a professional but since in current situation I need to replace of the switch in one of rooms. Situation is:
Current Scenario:
Plastic back box
Metal switch
Earth wire terminates in the...
Hello everybody,
I was experiencing some crackling when turning our kitchen lights on (2 gang 2way). I opened up the light switch to see if there was any obvious issues such as loose wires and I noticed the one loose earth wire. One earth wire to the light switch was wired to the casing and...
On my newly purchased wall light there is only a blue and brown wire and no earth. The connection from the wall however has brown, blue and an earth wire. My question is can I just cap the earth wire off and tuck into the light base? If so what is the safest way of doing this? Attached light and...
Hi
I have an intex inflatable spa and the moulded plug is hot to touch after running it for a few hours. I tried it in different sockets but it still gets hot so assume its the plug thats the issue. I cut the old plug off to attach a new one but there is only live and neutral wires. Is this...
Anyone got any memories ( for the Oldies amongst us) of running uninsulated earth wire, and trying to make it look presentable using those insulated staples that had to be used?
Hopefully a very quick question. Whilst looking under my sink this morning I noticed the Earth wire between the hot and cold pipes is no longer connected. I can't recall if it ever has been but I'm assuming this has come loose and I should reconnect it? If I do connect it should I take any...
Hi there,
I have been shortening some leads around my house so they look a bit nicer and tidier.
I am about to to the same to my lamp cable but i notice it has no earth.
Is it still OK for me to cut the cable and re wire the plug?
Also why doesn't this one have an earth?
Thank You.
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc