Hello engineers. I did EICR in two bed rented flat in a block of flats. There is old plastic fuseboard just above the entry door. There are only bs1361 fuses inside and no RCD. All luminaries are plastic.The board and wiring are in good condition. Any advise on how should i code that?
Hi all. First time poster here. I did find one thread on here that touches upon this topic, but my setup is a bit different. I want to install a TV antenna on the south wall of the house or perhaps the eve above it, The roof is concrete tile, so I don't want to try mounting anything up...
Hi,
I have what seems an unusual situation, and two electricians I've consulted say "I've never seen that before".
An outbuilding put up in the early 90's. They re-used an old 60 amp double pull 4 fuse panel. There is a 3 wire underground service line with two insulated hot aluminum stranded...
Hi. My PIR entrance light flashes on and off about 4 times before turning off at the end of its time cycle.
Any ideas what might be the cause/ remedy for this? It’s been installed for a couple of years and has only started doing this a few months ago. It’s bloody annoying now.
Hi every1,
i've recently been made redundant(worked as a concrete repair technician for 5 years) and am thinking of retraining to become an electrician.(C&G 2330 parts 2&3 would be my first step)
After having read a fair amount of threads on courses an education on this forum, came to the...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc