I fitted 5 Click 50W 240V downlights and a Click 400W dimmer. The dimmer failed after short time. I just tried a 400W dimmer from Denmans but it flickers badly more so when on turned round to the fully on position. There is a normal 1 gang two way switch at one side of the room and the dimmer is...
Hi,
Im having a bit of a problem with a job i recently went to look at for a friend. The problem was that when the shower was turned on the lights through out the house started to flicker. The shower is also very old and im nt sure what kW the shower is or the cable size due to only having a...
My downstairs hallway, Front Room and Living room are running off a 6amp mcb. In each is a 11w energy saving bulb. In the Front room i have installed 12 50w halogen spot lights on 1 dimmer switch all with dimmer bulbs. after installation all was working working fine as it was tested for a few...
Advice Please..
Installed a 1 gang double dimmer powering, on one side, a triple 3x50w halogen ceiling fitting. On the other side it powers 2 separate 50w halogen switched wall mounted spots connected part way down the line at a simple junction box housed in the roof-space.
The two separate...
All
Just replaced a Consumer unit new tails etc etc, when the electric shower kicks in it causes the lights to flicker.The shower is 9kw and is run in 6mm distance of about 8m. I have checked for loose connections. I'm going to load test with a clamp meter but I'm not expecting anything out...
Hi, i've just replaced some mr11 gu4 halogens with led lamps, they all work but ocassionally they flicker, there are 2 12v 105w transformers each with 5 lamps, only 1 set will flicker at any time so i'm ruling out a mains fault,
has anyone experienced anything similar? are there specific...
any ideas
going to look at a job tomorrow that has a very subtle flicker on the lights its a split board will and both sets of lights are flickering but are on different rcds will check the board for any loose conections but does anyone else have any idea's
cheers
jon
Hi guys. Got a bit of a teaser for you. Went to a job today and they had a problem with a very slight short flicker in a small office area on fluorescent lights when either a rip saw or a pressure washer are used from a small workshop area. The flicker lasts less that 1 second and the lights...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc