What do you use to cut up floorboards? Jigsaw/ circular saw or any other. I use a jigsaw but it is on its last legs and I have been usuing a reciprocating saw lately which is only going to lead to trouble when my luck runs out.
Hi all I am doing rewire for part P assesment ( was just a cu but no earths in lighting ect)
Anyway its tncs and its on 16mm tails with a switch fuse before the cu as it is about 3.5 M away from meter , am I right in thinking as long as it is fused for 16mm it will be ok?
also i believe I would...
Finnaly after 20+ years in the trade i have been caught and have to do a domestic rewire. I have had no experiance with them only done Industrial , commercial. All hints Tips and shortcuts are needed sure you have loads.
Hi guys, could someone give me some advice on how you lift floorboards? If I am lifting one or two I usually just use my Fein multimaster to cut over the joist on each end and along the tongue.
I was shown at college to use a floorboard saw but I find them so time consuming. My boss also...
Greetings brothers (and sisters!) I'm a factory spark whose re wiring a friends house on a building notice. Happy enough to do this but I have a question I would be grateful for opinions on. It concerns "throwing" cables across voids on the underside of floorboards, effectively resting them on...
In my bathroom & toilet I have unsightly hot/cold copper pipes above floor. There is no earth bonding on them.
If I move them to under the floorboards, do I have to have them earth bonded?
Do I have to use a qualified electrician to do them if so?
Thank`s.
Rumpel4skin
Thread
aus
bathroom
bonded
bonding
earth
floorboards
moving
pipes
under
water
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc