fuse | Page 7

fuse

Recent contents View information Top users
  1. D

    What are my options for replacing fuse panel????

    I have an older house that was built in stages back around 1960 as far as I can surmise. Highly suspect that the entire house was a DIY job. I've been unraveling the wonky wiring since day one. The original part of the house was wired with a fuse panel and 12 gauge wiring without grounds. I'm a...
  2. C

    Can you put a 32amp fuse spur off of a socket for an electric shower or does it have to go through consumer box?

    THIS IS FOR ELECTRICAL NEWS ONLY
  3. J

    Optima xm6 prob with control panel battery fuse.

    Hello. I have an optima xm6 alarm system. Could someone tell me the best and safest way to check a battery fuse on the board. Do i need to turn off the mains to the control panel or not as the board has an output of only 12v dc being stepped down by the transformer. Would it then be ok to...
  4. A

    What gauge cable from meter to fuse board??

    Hi, I just had a new 18th gen with surge protection installed. They disconnected the old cable and did a new run, the cert says 10 gauge was used but then I just had a different sparky who is looking to wire up my garage see it and say it should be 16. Just wondering what is correct and should...
  5. P

    Why is my AEG washing machine tripping my fuse box?

    Hi. I have been having a problem with my AEG 7000 Series Washer Dryer (L7WEG851R) tripping my main fuse box over the last week. I am trying to diagnose what the issue may be. Here is what has happened so far. The machine is three years old, so it is now out of warranty. Last week I ran my...
  6. K

    New 16A Oven and 30A fuse Cooker Circuit

    I am preparing for new kitchen and have a new 16amp built in single oven to replace the existing freestanding double oven. The existing oven is hard wired -this enters wall in a blanked off fitting-which i assume runs up to the Cooker Socket which has an on off switch and a plug socket too...
  7. M

    Do I need a rewire and new fuse box? Or is this OK?

    Hello - I’m a new member here seeking some advice. I’m purchasing a project property - sadly the previous resident passed away. I’m trying to work out whether I will need to have any major electrical work done or not. The property is fairly run down, but the electrics look like they might be...
  8. T

    Fuse carrier for Fusebox

    I have been to look at a friends flat that he lets out. As result of EICR he had to have the old Wylex fuse board changed for a Fuseboard consumer unit. all RCBO. This want done by me. After the electrician left, the tenant complained that the electric underfloor heating was tripping the...
  9. B

    Fluke 1653 fuse

    I have a fluke 1653 which gives me a fuse error, but only when voltage is present. Done some research but not found anyone with the same issue... just wondering if it’s time to retire the fluke as I know it’s getting on a bit now... just seeing if anyone’s had/ seen this before, I’ve tried a...
  10. E

    Supply a third fuse board for garden bar

    Hi guys, my brother is building a bar in his garden that is timber framed and wants some power to it. The main board in the house has a pme earth and there a no spare ways in the board. From this board there is a 4mm t+e on a 32amp breaker off the rcd side supplying a board in a little out...
  11. brs73

    Old fuse removal.

    Afternoon all. Does anyone know how to remove this fuse. !!! We’ve pulled it, undone the screws But it’s not budging. , it seems like there’s something mechanical holding it in place ???
  12. A

    Fuse Blows only when steering is full lock

    Hey guys, I'm 17 and had just bought my first car a 2005 Mitsubishi Triton and noticed whilst driving at night that the 10A fuse for my guage cluster bulbs and parker bulbs had blown. After replacing the fuse, after driving for about 3 mins the fuse blew again. I did some testing and the fuse...
  13. H

    Cut-Out Fuse Question

    Newbie Question: I know theres loads of posts about this topic, but IM due to change a consumer unit for a customer and had told them to contact their supplier to get an isolator switch fitted(they are having a smart meter fitted as well) and the supplier has said thats the DNOs responsibility...
  14. i=p/u

    Rcbo replacement fuse board

    a fuse carrier is broken in 6way mem board with no rcd protection , it makes sense to upgrade to rcbos like other boards in the installation.. My question is , I'm nearly certain there is borrowed neutral on the lighting circuits and he won't want a wire fitted from kitchen to landing to...
  15. richardg

    DNO fuse in a house of horrors

    Just been this sent this remotely by a former client who is just about to move into her ‘new house’, survey report did not flag any problems - builder was asked for his knowledge and said all’s good and now a smart meter fitting turned up and looked at this and scuttled away in terror? where to...
  16. B

    UK Please help with fuse size :)

    Hiya, just a quick question, i have bought a 240V AC to 12V DC power supply (12v 10A 120W) i will post a pic of it, im looking at runing some 3 core flex with a standard uk plug on the end to the power supply for the live feed, what size fuse should i put in the plug? thanks in...
  17. V

    Faulty main 100A Fuse

    For some reason I'm getting the strange and unusual faults at the moment. Got called a day or so ago to a tripping RCD. House is quite old and has a modern extension, so there were two consumer units. The fault appeared to be in the older board (I say older it was a board from 2015ish). Anyway...
  18. S

    Need Advice, Replacing Old Fuse Box

    See Attached Photos Sorry if this is posted in wrong place. Obviously just showing you guys a photo will never give a complete overview but any advice would be greatly appreciated. Also we do have an electrician due to visit by beginning of next week. We've lived in the house for 6 years (2...
  19. T

    Fuse Upgrade SSEN

    I have seen many people saying fuse upgrade from 60A to 80/100A would normally be free. Have anyone requested one with SSEN? They quoted £60 for me which is a reasonable price but just wanted to check if it was meant to be free.
  20. K

    sauna blowing 4amp fuse internally on switch on after water

    infrared sauna blowing 4amp fuse on switch on, After heavy storm, water damage, The water went into the roof of the sauna were the electrics are in a black box the fuse blows every time the sauna turn on switch is pressed. Image 1 is were the fuse is, I have removed the light and stereo wires...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top