fused | Page 7

fused

Recent contents View information Top users
  1. P

    Fused Spur Combined Socket

    Morning Looking for the above, does anyone know of a supplier please?
  2. H

    Is it OK to terminate switched fused spur with 13A socket?

    I am planning a new layout for our utility room and would appreciate some advice. We have three appliances (washer, dryer and freezer) that will sit under a worktop directly below the window. My intention is to feed this equipment via a row of three 13A fused spur switchplates located inside a...
  3. gazdkw82

    Spurs/ip rated fused spurs

    father In law grabs me and says "now we've had our extension finished can you help with some outdoor sockets?, they have put an outdoor socket on the side, can you connect the sockets that feed the hot tub back up into it" So on first glance there is an al weather IP rated twin socket on the...
  4. W

    Fused spur off ring main regulations

    hello I've seen the page at the back of the regs book but nothing explains can you - Have a spured socket off the ring using one cable and then put a fused spur after the spur and then feed additional sockets after the spir
  5. H

    Safe fused sour isolation palava

    hi there guys, I'm a lowly gas man but thought I would put my hand out to you helpful electricians to see if there is a better way to do the following! I work for a rather large gas service and repair company and health and safety as I'm sure you will know is going a bit bonkers at the...
  6. Dannyg8810

    For Sale Recessed fused desk sockets brand new

    x5 recessed desk sockets and leads all brand new These are approx £80 for the socket unit and £10 for the lead you need for them Need the space back so will sell cheap Any offers?
  7. L

    Switched fused spur problem

    Hi, Had a problem recently. Switch fused spur fed off ring main to control 6 x t8 5ft fluorescent tubes works when it wants, tried replacing fuses and tried a new spur, and keep getting the same problem. Its not overloading and havnt come across this before. Any ideas?? Thanks
  8. G

    GreenBrook KingShield T205-C Fused Timer Spur Switch 1/5/7 Day problems

    Hi, Just moved into my new house and have a GreenBrook KingShield T205-C Fused Timer Spur Switch attached to the immersion and controls the hot water in the house. The immersion doesn't seem to be working either (by the way) As it doesn't seem to be heating the water when I turn it to the...
  9. E

    Fused unit no longer required

    I've just removed an old fused electrical heater fitted in the middle of the ring circuit and am now left with the hole and wiring (see pic). Ideally I want to just cover this up with a bit off plasterboard so it looks like nothing was ever there. Is it OK to do this or is this deemed unsafe? I...
  10. E

    All the top floor lights have all gone out but the bottom floor lights and plug sockets are fine

    Hi everyone, Yesterday my sister switched on the bedroom light and all the lights o the top floor went out! there are six lights in total and none of them work at the moment. The lights on the bottom floor work and all the plug sockets on both floor's work fine too. I know next to nothing about...
  11. I

    20A Fused Switch or DIN mounted 20A RCBO

    Hi, My central heating wiring centre (Honeywell S Plan) is hanging off a 13a plug in the garage which is plugged into a double gang socket with integrated RCD at waist height close to where I would to fit a sink. I'd like to move the wiring centre much higher up the wall so it is out of the...
  12. P

    Adding a socket from a Fused spur

    I wanted to know if a radial circuit that has a fused spur at the end of the circuit can then feed a double socket if I use a 13amp fuse in the fused spur? Also would that then have enough power to run a washer and maybe a chimney hood fan above a cooker hob?
  13. A

    Theoretically... cables must be fused down when a lower size cable is connected to a larger sized ca

    Now I completely understand why cables must be fused down when a lower size cable is connected to a larger sized cable. To ensure the cable does not burn out from current that it cannot take. Yes i know this Now current doesnt go anywhere it isnt in demand for so if a spur off of say a 6mm for...
  14. B

    Installation of WarmUp Loose Wire System - How To Fuse?

    Hello folks, I have just finished installing a WarmUp DWS600 loose wire system in my bathroom. A little more on it here, but essentially it's rated at 0.6kW / 2.6 amps. Warmup DWS 600 Loose Wire Underfloor Heating Kit -...
  15. Pat H

    FCU for Extractor fan

    Adding an extractor fan off of a 6A lighting circuit. Installation instructions specify a local isolator (as I would anyway) so 3 pole isolator will be used. Switching L SL and N however should I have an FCU upstream of the live? It would be 6A fused as specified which seems pointless the RCBO...
  16. M

    In line fuse holder

    Got some coastal apartments which have a mixture of downlights, pendants and 5A round pin wall plugs all controlled by conventional light switches and everything is switch fed. OCPD is a B10 mcb which if I derated it to a B6, would still be over the 5A rating of the sockets and plugs. All the...
  17. Dave

    Can you feed 2 radials from one fused spur

    Before I start, I know this is not usual but I want to know if it's against regs. I'm testing a conservatory ring, feed from a fused spur. There's a Live-Neutral IR fault between two of the three sockets. The cable is embedded in the conservatory bare block wall. If I just disconnect the faulty...
  18. A

    Xpelair 12v humidistat fan

    Hello all, I am looking to install an xpelair 12v fan in a bathroom with a humidity sensor (model no. 92970AW). I can't quite work out from the instruction manual whether the humidity sensor is in the fan itself or in the transformer. due to the size of the bathroom and the position of the bath...
  19. D

    Fused spurs

    Hi guys, I understand that when you spur off a circuit if you have a 1 socket then you do not need to have it fused but if you have 2 or more it needs to be fused. What is the principle behind this? Thanks
  20. I

    RCD fused spur

    Query regarding a Passive RCD fused spur unit protecting a bank of 4 led downlights supplied via switched live and nuetral. I have been asked to replace the downlights. Cant be totally sure but i think RCD spur was to protect the (addition)of the downlights. The rcd is passive so will remain...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top