Hi all, is it acceptable or was it in previous regs if not anymore? To take the gas bond straight off the TNS connection shared with main Earth? See pic.
Thanks
Paul
is it okay to bond the gas and water at the boiler?? Gas meter is tricky to get to, was going to just take a 10mm to water pipe at boiler and just loop across to gas supply at the boiler
Does a copper gas pipe, coming into the house require bonding when the pipe is being supplied by propane cylinders, via rubber hose.
Doesn’t go underground at any point.
The water pipe is bonded, and therefore connected to gas at the boiler, which is at the point of entry of the gas…. Can’t...
Hi,
New to the group.
I am looking at expanding the number of panels on the roof with an additional inverter and currently have an application into the DNO but I have 2 questions as trying to workout the best layout within the garage. I don't want to engage an installer at this stage unless...
A 'Sunday challenge' for the qualified electricians....
Can anyone explain why a built-in gas meter housing box
that is located 600mm above a block paved driveway, with a plastic (Polyethylene - MDPE) supply pipe and no extraneous conductive part, could result in a dangerous potential...
Apologies that this is a plumbing question, but I'm sure there will be people here who can answer this.
Working in a house today that is in the middle of a total refurb (gutted, rewired, replumbed, etc).
The gas supply is currently disconnected inside the house (in the hall), about 2m after the...
I am changing my oven to a gas only oven and wanted to know if it was sufficient to put a blank plate on the original socket as it is will be close to the oven. Any help much appreciated.
Hello I’ve recently started an electrical apprenticeship was just wondering if I’ve made the right choice between that and doing gas in terms of money in the future and job opportunities, thank you
Stillorgan Electrical submitted a new resource:
Stillorgan Gas, Plumbing & Electrical - Stillorgan Electrical Services is South Dublin's fastest growing electrical company
Read more about this resource...
Good evening
Have to quote on a consumer unit replacement, problem is gas meter is next to existing consumer unit 25 mm between them, they are both in a wooden cupboard,
What would you do
Hi Guys,
I'm looking for some opinions, I've got a customer with a gas meter in an in ground box (see picture). The pipe to the meter is plastic as the meter was moved a few years ago but its metal where it enters the house from the outgoing side of the meter.
Would you bond this?
The customer...
Hi guys
I’ve seen people state in forums that it is permissible to bond a gas pipe as a continuation of the bonding of the rising water mains. Can anyone supply proof/documentation/official guidelines etc., where this is explicitly stated.
Below is an image of what I am planning. My gas safe...
I'm adding a 30 amp RV outlet to the exterior of my house.
The location I'd like to put the outlet happens to be near the gas main/meter.
Are there any safety or code issues putting an outlet near the gas meter?
So , I was just eating my toast and watching Sky News (very rockstar I know) and I saw a Gas Safe register advert saying you can look online at gassaferesgister to see if your builder / plumber is registered and qualified to do gas
Which got me thinking, when was the last time anyone saw a TV...
Hi, quick posting - welcome any advice as new to this stuff...
Have a Howden HJA 0150 gas grill/oven with a broken thermostat that and can't get a replacement (grill igniting but no gas coming out of oven burners when on).
The Howden grill/oven is on a ring in the kitchen which has following...
What do you guys think about using decommissioned gas pipe which is welded throughout and 4" industrial in steel.
I am clear on regs that say you cannot utilise a gas, oil or water pipe as a bonding conductor but this would effectively safe a lot of time and money.
Hello everyone,
I am buying a property where the current owner has a EICR stating unsatisfactory due to (3.1g) main gas bond omitted and gas installation pipes.
The report also states the following overview:- **General condition of the installation (in terms of electrical safety):
Wired to...
Good Afternoon Team,
In this current climate of gas prices going through the roof, I want to change the Gas Hob to Electric.
Gas hob needs capping off
I have an electric oven in an other area of the kitchen, Can I Parallel the Hob and Over together
The Oven, is, one main oven, and a...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc