Hi all,
I have a Dimplex Quantum Storage Heater displaying the message "school lock". None of the buttons are working as a result. Any ideas how to rectify this?
Thanks!
I use my shed for pottery and it’s currently wired to have 2 sockets and a light switch (fused down from one of the sockets). Currently I draw less than 300 watts of power. As it’s getting cold I’d like to plug in a heater out there but my husband says it’s not a good idea as my shed isn’t...
Hi.
I've been asked to install a Dimplex qm150 storage heater for a customer. There is a suitable existing supply for the off peak element.
Someone has installed a switched fused spur to supply the boost functionality. This has been taken from a nearby socket circuit.
However the property has...
Had a quantum (qm150) installed for 8 years - no problem.
Couple of weeks ago the switch (usually always on except when on holiday) stuck and no power to heater.
Had a look at switch and saw it was melted where the N wire goes in.
Bought an exact replacement (B+Q) and replaced myself with the...
Hello,
Apologies if this type of question has been asked before. I have no gas in my house so rely on a water heater to heat the water tank. The water heater is a Horstmann Economy 7 quartz model. I have found the pdf manual online that vaguely describes how to change the timings the heater is...
Just an idle thought - has anyone any experience of using the DC output of solar panels to directly feed an immersion heater, to avoid the expense and losses associated with an inverter? Evidently, a changeover relay would be required to utilise the usual 240V AC supply at times of low or zero...
Hi all,
Yesterday I returned home to no hot water after a few days away.
After a brief inspection it seems the fault lies with the Horstmann Electronic 7 Water Heater.
The display is still visible but the controller is completely unresponsive. If I select either of the following buttons...
Hi,
We have an old storage heater (FGS Storad COH 972A). Guess it's around 30 years old.
It's a dual rad - storage and convector heater.
Stopped working last winter. I opened it up (after turning off the power!) and noticed one of the cables was burnt and snapped).
Also, noticed one of the...
Hello,
Question is regarding a recently purchased property in Central Texas, which includes a 27KW tankless electric water heater. It is four years old and working fine.
What the prior owner installed is surely not code compliant, but the county does not require permitting for "renovations...
Heya I have a pct heating element for an egg incubator it’s 220v 80 w
atm it’s wired to the old circuit but mid incubation all the digi display started flickering and now I can’t read the numbers
I baught an external plug in thermostatic controller for lizards you plug a uk plug into and it...
Just wondering if someone with more experience can enlighten me, called out to a bar today. Plumber was in to replace immersion element but FCU was faulty and wouldn’t switch off . Noticed that both the top and bottom elements were being supplied from the local ring circuit and were constantly...
I have two baseboard heaters (1000w and 1500w), both 240V. They are in different rooms of the house. I want to run them on the same 240V circuit- 15A. Two questions: can I put both on the same circuit? And can I simply connect them in a junction box near the panel?
Hi there
I’m looking for some help as I have what seems to be an electrical issue. It seems to relate to my computer PC, the fridge freezer in my kitchen and my electrical heater.
My computer PC tower is connected to my smart TV so I can use my TV as a PC monitor as well as a TV. The problem...
Hi.
I've taken my immersion heater out and want to replace it with an instant hot water heater.
The unit will be placed on a wall at chest height from where the immersion heater control was sited (Horstmann economy 7 quartz)
The fuse on the fuse board says it's a 16A.
I only need it to heat...
I currently have a well water set up. I have an electric water heater (50 gallon / 240v / 30 amp breaker). It is on its way out and I would like to upgrade to a tankless water heater (electrical would be the easiest / although I do have propane on the property). The tankless water heaters that I...
Hi all
Have had a request from customer that would like their immersion heater controlled via a Nest. It has standard 2 elements and is not on Economy 7. My initial suggestion was to just put in on a Horstmann timer but he is adamant would like it on Nest, has bought the bits already including...
Still have an old clock timer for our immersion, but thinking that using our oil boiler during the summer is possibly going to be more expensive than electric on overnight economy 7, what do you guys recommend,
I have a 10kw heat pump for my above ground swimming pool. I was wondering if possible what sort of turbine I would need to run it so as to keep costs down?
This is a general wonderment at the moment
Hoping someone can give me some advice.
My cyclinder immersion thermostat is tripping every few days.
It hasn't been used for a few years, but now, because I got Solar panels and an Eddi connected, we've started using it again.
I've established that the Eddi, nor the top thermostat, is faulty...
Hey there.
I got a question. My heater just died and the only real way to fix it is to get a new thermostat but sadly I cant find the modell at all.
Now my question is I got a workaround but before I do so id like to ask if it will work.
There are 2 cables going to the thermostat. One is going...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc