I will be using an electrician but I will have to buy the fixtures. The base plate for most new Flood Lights are small 3 - 4 inches and and don't appear to be durable . Old one is about 5 inches and metal . I need a lot of light down my driveway. Will there be any problems using a GE 3000...
I just done some work for a new landlord and ok he has paid me on time , he rang up querying the bill i had sent him ,but i dont often work with some landlords only a selected few, either they dont want to pay or i have to keep chasing me tail to get the money out of them ,new landlord how...
Just been down to the basement to check what I've got. The supply to the (old) house comes from an 18mm cable, is split out to a live and neutral, goes to a 100A fuse and single-phase meter, and on to the consumer unit.
So, it's obvious that I've got single phase. But here's the problem: a...
Hi All
Wondering if anyone can clarify / advise on the following situation.
Have a friend who is in the process of buying a new hotel / guest house (10x bedrooms) they have asked us if this falls under the new regulations with regards to EICRs being carried out.
The bigger picture is ... the...
Hi, looking for suggestions or indeed what you guys do when wiring in SWA to plastic house CUs.
gland swa to a Metal JB then connect from JB to CU?
Fit sub main like the wylex fused isolator using 25mm meter tails via henley blocks to keep supply out of house CU rcds?
fit gland plate/nut to...
Hi folks - new to the forums here. Forgive me if this isn't the right place to post. We have a small home, just moved in and noticing that 24 hours a day, once about every minute, ALL the lights in the house flicker at a pretty fast rate for about 10-15 seconds. It repeats this cycle 24 hours...
Hello, I need some electrics to my new wooden man cave. It is 10 m away from the house, I need need lights and sockets for the fridge and electric heater. I have no space in consumer unit but two ring mains down stairs (kitchen and then all other rooms) onto 32 amp MCB's.
I have been told that...
My shed already has a breaker box and is wired already. My house is 165 feet away my breaker box has a spare 20 amp. What size wire do I need to purchase I want to bury the wire aswell I will be using lights in the shed aswell as plug in to power tool all of which are 110 tools no 220 I will run...
Moved in to a ground floor flat of a house broken up into individual flats, only found two outlets in main living area (No bedroom and 1 double in kitchen plus double for oven).
I checked the consumer box and feel it doesn't look right, not an electrician just a handyman who recognises his...
Hi,
Does anyone provide backup power for when having to turn off power to an occupied house for long periods of time ?
I've got to turn off the power to a house next week to trace a ring final fault and it's likely to take all day and the house will be occupied with a young family so they will...
Just had a full property rewire completed, My contract was with a registered electrician ( sparky 1 ) , I checked prior to engaging him and he is registered with NIC IEC
The job took five days and the electrician had another electrician working alongside him
When the job was completed I was...
Just been this sent this remotely by a former client who is just about to move into her ‘new house’, survey report did not flag any problems - builder was asked for his knowledge and said all’s good and now a smart meter fitting turned up and looked at this and scuttled away in terror?
where to...
My mate has built a summer house on to the side of his house. He wants to
install two double sockets and a light.
can we spur off the ring main( which is rcd. protected), with a 30 amp junction Box to a
un switched fuse spur then two double sockets.
am I right that if he wants to use a...
I have 200amp connection, with the meter and service disconnect at the road (see pictures). House panel is about 75 feet from the service disconnect at the road.
1) Assuming I need 4/0-4/0-4/0-2/0 AL wire sizes (considered a sub panel), exactly what type of wires are required to run from the...
Hi everyone, I live well off grid in Wales and am presently renovating a small property. As part of that renovation I have had a full off grid solar system professionally fitted coupled with a generator back up.
The inverter charger has a neutral earth link as does the generator. The inverter...
I’m looking for some whole house transitional or contemporary lighting fixtures to replace my ugly builder lights. All the ones I can see are either too cheap or for smaller places. If I look at larger home real estate listings to get ideas, they all seem done up in a traditional and showy...
sometimes when I touch metal objects for example the washing machine, toaster etc I get a nasty shock. almost always the breakers trip, what can it be? Also I am not an electrician I am just curious as to what is the problem. The problem is not happening all the time. sometimes nothing happens...
Just wondering your take on this, EICR on property, New DB fitted some years ago, looks ok. & compliant @ the time of install but not now.
Its all pvc T&E cabling but with the usual poor workmanship recess lighting,wall lights not ideally connected.
Polarity issues @ lights & sockets,no...
A circuit in my house quit working when a toaster oven and portable electric heater where both running on it. Normally the simple fix would be resetting the tripped breaker. However, the breaker did not appear to be tripped. I turned it off and on just to make sure and still no luck. Next...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc