Ive been called out to about 7 different jobs this week!! All to check why newly fitted immersion heaters were not working properly.
Its always the same thing. Plumber fittied new immersion heater and since then the water doesnt get fully hot or after the 1st bath the water wont heat up enough...
I know this subject has been covered many times but my simple question is:
We use an oil fed boiler for central heating to our home and for hot water.
During spring and summer we usually switch off the central heating and just use the oil boiler for supplying our hot water. Usually fired up for...
Just found Solar Panel Immersion Heater Switch - Use Surplus Power To Heat Water | eBay
Has anyone tried one of these?
Do not know if there is any garantee with it but have asked the question.
To be cost effective it has got to last several years
Can some one help, i have been asked about an immersion heater which stopped working so she pressed the reset button on the temperature control, which worked for a while but now the timer has burnt out, any ideas what i should look be looking for when i go round to look at it. would a fault in...
ample current
Thread
electricians' talk
heaterimmersionimmersionheater
problem
timer
Customer has an immersion heater that has a melted plastic cover, the Thermostat has been replaced as inadequate cable size used to connect and excessive heat caused the damage. Been asked to replace the cover, cannot seem to find one anywhere without purchase of a complete element and cover...
Evening all.
Just had a callout to an immersion heater making wierd knocking sound within 30 seconds or so of being switched on. Seems to be the thermostat in the dry pocket and if I hold the thermostat then the knocking stops.
Polarity, voltage etc correct. Top 22" immersion heater...
Need...
sparkypants
Thread
aus
electricians' talk
element
enough
heaterimmersionimmersionheater
maybe
termostat
thermostat
Hi all, I am aware that there have been several threads regarding using pv to power the immersion and how to control the turning on of the same when the system is producing sufficient surplus output.
I have had a 3.84kw system installed for several weeks now and like everyone else want to make...
Made the fatal mistake of offering to do a friend a favour which always comes back to bite you. Its a one bedroom flat with concrete floor and ceiling and only one ring final circuit for sockets. Wants panel heaters fitting in the hall 1.25Kw and bathroom 0.75 kw so i said i would run a new...
olsonn
Thread
aus
circuit
electricians' talk
heaterimmersionimmersionheater
trunking
using
I have a question, basically can i heat my water using my immersion and the power from my 4kwpv system? I am trying to get the most benifit from my recent pv system install and think this is a good idea, any thoughts?
ihave4kw
Thread
electricians' talk
heaterimmersionimmersionheater
power
system
All,
About 50% of the houses I've been in recently have had additional connections added to the immersion heater circuits. The most common is a socket or FCU for a shower pump.
In my mind BS 7671 says that water heaters should be on their own circuits.
Bearing in mind that the vast majority...
Octopus
Thread
additional
aus
circuit
circuits
connections
electricians' talk
heaterheaters
immersionimmersionheater
radial
Please dont take the mick, as I am sure there must be a simple solution for this. I have got to put a timer on immersion heater that is on an eco 7 supply. They want it to kick in for an hour in the morning. Im sure its blinkin obvious, but I have not really work on eco 7 before, so Im...
Southern Spark
Thread
aus
economy
economy 7
electricians' talk
heaterimmersionimmersionheater
Hi folks, when carrying out a domestic PIR, do you include an inspection of the central heating immersion heater for old style single contact type? (Of course assuming that fixed wiring up to the immersion is tested as normal). If yes:
1. If it is old style single contact, what code would you...
SW1970
Thread
domestic
electricians' talk
heaterimmersionimmersionheater
inspection
pir
testing
I have a customer who had a fault on there immersion, they've lived with this fault for about 8 months and just relying on the boost to give them a quick short supply of hot water. They said it used to work fine, no problems then just went off,
So after going and having a look it was just there...
TPES
Thread
aus
electricians' talk
element
fault
heaterimmersionimmersionheater
thermostat
water
seem to be getting a lot of problems with the high limit stats on new immersion heaters tripping out have tried several makes they all seem to have the same problem is anyone else having the problem or found an answer :angry_smile:
littleeley
Thread
aus
electricians' talk
heaterimmersionimmersionheater
limit
Mate asked me to look at his immersion heater that had stopped working. The tank has two elements - labelled 'On Peak' and 'Off peak'. It is the off peak one which has failed. No breakers tripped but the neon on one of the switches (off peak) is out. I've measured around the circuit - no power...
Harry Worth
Thread
aus
electricians' talk
heaterimmersionimmersionheater
no power
power
power to
hello, having a problem with an immersion heater causing a 16 A RCBO to trip it is definately non of wiring with a fault on as all been tested and powered up without imm connected. have tested imm (3kw) continuity 19 ohms (fine).and insulation resistance to earth >1000 ( fine). i have heard that...
hi.been asked to do a periodic test on a holiday let in north wales, I came across a number of problems.
the immersion is a bs 3456, I presume this is pre dates bs 60335/2/73 and the bs 3456 has no cutout. is this correct.
thanks
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc