I'm considering buying a domestic 4kW PV with 6kWh of battery storage and a 5kW hybrid inverter from Sungrow.
My problem is that wife's electric car has a 7kW Podpoint charger. I assumed that the hybrid inverter would pull power from the grid when the house demand exceeds 5kW, but there's no...
After several asks,been told that an inverter speed controller cannot be used on a 3 phase 2 speed,4 pole motor.
All the tech guys,installers etc,couldn't tell me this at the beginning of job,but when testing the motor,it just didn't sound right,2 motors later one call I've made as finally...
Kindly, we are trying to do a modbus rtu communication between a Delta plc and an ABB solar inverter.
It runs ok during the day, but each night the modbus rtu communication stops due to an unknown cause, and we have to restart the plc each following morning to have everything normal again .
We...
Any tips about putting in an inverter for a 3 p motor,client wants high & low speed,controlled by air sensor relay.
Just wondering who actually commissions & sets all the parameters etc.
Hi all. I recently had a 300w inverter go pop and I'd really like to try to repair it if possible (it's a valuable part of a solar energy system). Upon first inspection, the big metallized polypropylene film capacitor right next to the AC output has burnt. I've no idea if there is any further...
Hi all,
fault on a inverter i installed 5 yrs ago, packed it all in then also so dont know much about these has i havent kept up with it all,
i think the inverter was eversolor if i remember , going to look tomorrow
ive attached piccy if you dont mind looking over guys and if you can help...
Been asked to replace an old consumer unit, PV installed so bonding etc up to scratch.
House supply is TNCS, however with the PV wiring the inverter (Fronius) is on its own earth stake! So that makes 2 earthing systems in close proximity! Why would they want to earth stake the inverter?
Just started doing my solar array. I'm 2391 trained but never done any solar before
Wanted to know do I need to earth my PV rails. I'm using a Solar edge inverter. If so is it 10mm back to board. Thanks.
Also is it worth putting Rcd and M C B straight off AC side of inverter
Hi,
I bought a 4.57Kw PV system (14x SunPower 327W panels) for my house last year.
I now noticed that the installer fitted a SE4000 Solaredge which is limited to 4Kw.
I can see from my stats that the system goes up to 3.98Kw but never above. It just goes flat and stays at 3.98Kw (especially...
Hi
I am buying a new Motor home, & want to do away with my generator.
I know that running an inverter draws a lot of power from a Leisure Battery.
I found this site that recommends connecting a pure sine wave Inverter to the Engine battery, rather than the leisure battery.
I only need to use it...
And it was pretty much as you'd expect. A bland couple of days where the most interesting things came about when we came away from the work and chatted about the industry etc.
Only three guys on the course and they only have one every 6 weeks. Make of that what you will. The guy taking the...
Hi all
Very strange situation this evening. I installed a PV system around a year ago and has been working fine.
Called out today as the generation meter had stopped increasing. Customers been away and only arrived back today.
Western Power have recently put up a new pole in the customers...
Hi we noticed our solar must have fused and tripped out the consumer unit for most of September which is really annoying - all that sun! we reset and now it has done it 3 times over this week. What could be the cause? we have never had any problems. We live in Swindon but the installation was...
Hi all.
Brought a van for the 1st time instead of leasing. Going to rack it all, awning, lights on back for external use, the whole 9 yards. A workshop of wheels.
Thinking of putting and leisure battery or inverter in, want to able to power a few 18v 4.0ah batterys, couple of LED battery...
AS the Queen song goes.
Just got another call - system installed by a now non-trading concern, fried inverter, Samil in this case.
The question is, what do you replace them with - Samil only had a 2 year warranty.
Like for lIke?
Something with a longer warranty?
ABB / SMA ?
Hi
Can you advise please regarding phase 3..
I've an auto hacksaw machine in my workshop.. The workshop runs on 240v supply..
The 240 volt supply runs to a Mitsibushi inverter as per pic below..
This is wired to a New Brooks Compton electric motor which is 3 phase.. The plates details...
Hi just about to install my first solar system. Been a commercial electrician for 29 years but no PV experience. After pushed away from Micro inverters by advice from people on here I decieded on Solaredge.
Have sized my system on the solar edge designer software. Now thats telling me I need a...
Hi guys,
So basically I'm coming here looking for some friendly advice with the intention of eventually getting an electrician out to make sure I'm not messing anything up (I'm based near Swindon - recommendations welcome!). I just want to do as much of the prep as possible.
I've put together...
Hi I'm a qualified electrician but new to car electrics. Basicly want to do a mate a favour he needs to to run a 1200 watt 230v cement mixer for about 20 minutes at a time. So i've googled and you tubed and recon i'm nearly there. Im thinking connect the starter battery under the seat to a deep...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc