Has anyone had an intermittency issue with a Sonoff DIY MINI smart switch?
This switch takes a voltage-free switch circuit (i.e. your old switch cable(s), separated from the mains) across it's inputs S1 and S2. Any change of state of the light switch(es) will change the output of the device...
Hi,
I have an LED landing light, which has 9 G9 LED bulbs. The unit has two switches, one upstairs and one downstairs. Ive found that when the upstairs switch is in the closed circuit position, but the light is off due to the downstairs switch being in the open position, there is still a very...
My wifes been decorating and removed the cover of a pir sensor. Alarm went off as it should. However after replacing cover the alarm wont set and keypad displays check hall PIR. I have come across these snapped wires to what im guessing...
I have a Keston C36 Combi boiler. Stuck in heating mode. I have changed the diverter motor as not moving to transfer across. This didn’t fix the issue. I’ve now changed the capacitor that drives the motor. Again nothing changed. Any ideas on what else it could be?
Recently been to a job to fix a D.I.Y fault on a lighting ring but can't figure ...
So , client rings , outside flood light stays on all day .. there's no switch and she doesn't know where the power comes from .. I find power using a wire tracker .. and it leads to a double switch in the living...
I changed a light switch in my master bath that had 3 black wires into the switch. I kept them oriented in the same way on the new switch, but now the light in my hallway bathroom doesn’t work. Why is this ??? I haven’t changed any other wires and I have checked the breaker. House was built in 1977
Hi guys
I'm installing a CU in a new build and have a couple of questions I need some guidance with regards to the meter tails.
I need to drill a hole through the wall (for the meter tails) to access the main supplies which are located in the recessed box on the outside of the property. I am...
Hello guys
I own a BMW E39 which developed a crank no start issue. No codes are being thrown but my initial thought was fuel. So I checked the fuses (all ok) and then moved onto the relays. I removed the relay and its ok then checked the socket and discovered the relay base is showing 4v on the...
Newby from Tasmania. After replacing failed Zetter a/c relay following 031, a quick, cheap and simple operation, there is now an intermittent 013 fault indicating Wrong Mode. Sometimes inverter operates for hours without failure sometimes only a few seconds. During the automatic restart...
Hey all, just wondering your thoughts on the following.
During perodic inspection and testing I have came accross an out building/shed separate from the house powering lights on 2.5 1.5 flat twin and earth. This has been plugged into the house ring into a non RCD socket but with an RCD back at...
Hello all!
I work in maintenance and one of the properties I maintain has a issue with the timer switches in the corridor. They don’t turn off when you press any other switch other than the master switch and it seems to function normally. However I did notice that when you press a two of the...
OK, this is just odd, we have a wall mounted TV, fed from 1 side of a Dual Socket. The other side of the same socket feeds 7.1 Amp an Android Box and a Router. The Socket is on the Ring Main on the main floor, with 8 other Sockets, on this Floor and upstairs. Also, as I discovered yesterday...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc